Medical Physics ( IF 3.2 ) Pub Date : 2020-12-26 , DOI: 10.1002/mp.14629
[https://doi.org/10.1002/mp.14227]
In the article cited above1, errors have been identified in the sections listed below.
Summary of updated performance recommendations
Page e922 (2nd paragraph, line 11):
Once set, Lmin is added to Lamb to determine the minimum combined luminance, Lʹamb …
should have been:
Once set, Lmin is added to Lamb to determine the minimum combined luminance, Lʹmin …
Page e922 (3rd paragraph, line 2):
… luminance, Lmax (Lmax + Lamb), by multiplying Lamb by the desired luminance ratio, LR.
should have been:
… luminance, Lʹmax (Lmax + Lamb), by multiplying Lʹmin by the desired luminance ratio, LR.
Page e922 (4th paragraph, line 2):
The luminance response describes the relationship between individual gray levels between Lmin and Lʹmax,
should have been:
The luminance response describes the relationship between individual gray levels between Lʹmin and Lʹmax,
Comparison with the other standards and guidelines
Page e924, 2nd paragraph, line 8:
… ambient lighting conditions.ipt1,3 As explained in …
Should have been
… ambient lighting conditions.1,3 As explained in …
中文翻译:
勘误:尼古拉斯·BB,迈克尔·SS,奥尔多·B等。AAPM报告270在显示质量保证中的实际应用:任务组270的报告。2020; 47:e920-e928。
[https://doi.org/10.1002/mp.14227]
在以上引用的文章1中,以下各节中已识别出错误。
更新的性能建议摘要
页面e922(第二段,第11行):
设定后,将L min加到L amb,以确定最小组合亮度Lʹamb …
本来应该:
一旦设置,L分钟加入到L AMB确定最小亮度组合,L'分钟...
页面e922(第3段,第2行):
…亮度L max(L max + L amb),将L amb乘以所需的亮度比LR。
本来应该:
...亮度,L'最大值(L最大+ L AMB)中,由L'乘以分钟由期望的亮度比,LR。
页面e922(第4款,第2行):
亮度响应描述了L的个人灰度级之间的关系分钟和L'最大值,
本来应该:
亮度响应描述L'之间个人灰度级之间的关系分钟和L'最大值,
与其他标准和准则的比较
页面e924,第二段,第8行:
…环境照明条件。ipt1,3如…中所述
本来应该
…环境照明条件。1,3如…中所述