This document is a corrigendum for the paper entitled “Shear property of oil film containing oiliness additive in narrow gap measured with newly‐developed parallel‐disk viscometer supported by aerostatic bearing”.1
FIGURE 5
Open in figure viewerPowerPoint
Shear forces for two kinds of base oils measured under various pushing forces [Color figure can be viewed at wileyonlinelibrary.com]
FIGURE 6
Open in figure viewerPowerPoint
Gap estimated from shear force properties of base oils. Gap values under constant pushing force were virtually stable regardless of rotational speed and oil viscosity [Color figure can be viewed at wileyonlinelibrary.com]
FIGURE 10
Open in figure viewerPowerPoint
Oil droplets for measurement of contact angles for PAO30 on noncoated and oleophobic coated surfaces
Subsequent to the publication, the authors would like to add the label captions for Figures 5, 6, 10, 11, 13-5, 6, 10, 11, 13, and 15. The corrected figures are as follows:
FIGURE 11
Open in figure viewerPowerPoint
Shear force properties of PAO30 sandwiched between upper specimen and noncoated/coated lower disk [Color figure can be viewed at wileyonlinelibrary.com]
FIGURE 13
Open in figure viewerPowerPoint
Shear force properties of pure PAO30 and PAO30 with 0.3‐mass% palmitic/oleic acid [Color figure can be viewed at wileyonlinelibrary.com]
FIGURE 15
Open in figure viewerPowerPoint
Cross‐sectional image of Cu surface/lubricant interface captured by FM‐AFM. The base oil was hexadecane and the acid concentration was 0.01 mass%. The detailed information on the capturing method is described in Hirayama et al.13 The substrate was Cu because the bright area was almost not observed when we used Fe substrate instead of Cu one [Color figure can be viewed at wileyonlinelibrary.com]
京公网安备 11010802027423号