当前位置: X-MOL 学术J. Frict. Wear › 论文详情
Our official English website, www.x-mol.net, welcomes your feedback! (Note: you will need to create a separate account there.)
Effect of Severe Plastic Deformation on Wear Resistance of Sintered Al–Sn Alloys under Dry Friction Against Steel
Journal of Friction and Wear ( IF 0.5 ) Pub Date : 2020-06-25 , DOI: 10.3103/s1068366620030149
N. M. Rusin , A. L. Skorentsev , E. A. Kolubaev

Abstract

The effect of equal channel angular extrusion (ECAE) with route A on the wear resistance of sintered Al–Sn alloys has been studied in this work. The tribological tests were carried out according to the “pin-on-disk” scheme without liquid lubrication. It was established that multiple processing by this method leads to the strengthening of the aluminum matrix and the formation of a structure with alternating Al and Sn layers which is favorable for the self-lubrication process. The wear resistance of the sintered Al–Sn alloys is increased as a result. However, the number of ECAE passes should be limited to two to three because a fragmentation of thin tin interlayers and destruction of the layered structure take place after large number of the passes.


中文翻译:

严重塑性变形对烧结铝-锡合金干摩擦磨损性能的影响

摘要

在这项工作中,研究了路径A的等通道角挤压(ECAE)对烧结的Al-Sn合金耐磨性的影响。摩擦测试是根据“针盘式”方案进行的,没有进行液体润滑。已经确定,通过这种方法的多次处理导致铝基体的强化以及形成具有交替的Al和Sn层的结构,这对于自润滑过程是有利的。结果,增加了烧结Al-Sn合金的耐磨性。但是,ECAE通过的次数应限制为2到3,因为在多次通过之后会发生薄锡夹层的碎裂和层状结构的破坏。
更新日期:2020-06-25
down
wechat
bug