Designer Direct Ink Write 3D‐Printed Thermites with Tunable Energy Release Rates,Advanced Engineering Materials

当前位置： X-MOL 学术 › Adv. Eng. Mater. › 论文详情

Our official English website, www.x-mol.net, welcomes your feedback! (Note: you will need to create a separate account there.)

Designer Direct Ink Write 3D‐Printed Thermites with Tunable Energy Release Rates
Advanced Engineering Materials ( IF 3.4 ) Pub Date : 2020-06-22 , DOI: 10.1002/adem.202070026
Elliot R. Wainwright _{1,

2} , Kyle T. Sullivan ₂ , Michael D. Grapes ₂

Affiliation

Direct ink write 3D printing of thermite into architected structures can be used to tune the reaction propagation and energy release rates. Lattice and channel structures are used to control energy flow pathways and increase the energy release rate by more than one hundred times over maximum print density thermite strips. Ashby plots are presented which highlight the design tradeoffs. Further details can be found in article, number 1901196, by Elliot R. Wainwright, Michael D. Grapes and co‐worker.

中文翻译：

Designer Direct Ink Write 3D打印的铝粉，能量释放速率可调

将铝热剂直接墨水写入3D打印到结构结构中，可用于调整反应传播和能量释放速率。晶格和通道结构用于控制能量流动路径，并且使能量释放速率超过最大打印密度铝热剂带的一百倍以上。给出了Ashby图，突出了设计的权衡。可以在Elliot R.Wainwright，Michael D.Grapes和同事的文章编号1901196中找到更多详细信息。

更新日期：2020-06-22

点击分享查看原文

点击收藏

公开下载

阅读更多本刊最新论文本刊介绍/投稿指南11