This study considers the influence of carbon nanotubes (CNTs) which are single-walled carbon nanotubes (SWCNTs) and multi-walled carbon nanotubes (MWCNTs) in indium oxide (In₂O₃) for dye-sensitized solar cells. The thin films were prepared by sol-gel method annealed at 550 °C using 0.3 wt.% of CNTs. The result showed the thin films are of body-centered cubic phase. The crystallite sizes of In₂O₃, In₂O₃-MWCNTs and In₂O₃-SWCNTs were measured with 63, 43 and 30 nm, respectively. Although the morphology analysis showed very rough surface area for In₂O₃-MWCNTs, In₂O₃-SWCNTs exhibited greater photovoltaic performance. The In₂O₃-SWCNTs-based DSSC exhibited good photovoltaic performance with power conversion efficiency, photocurrent density, open circuit voltage, and fill factor of 1.02 %, 5.01 mA/cm², 0.43 V and 0.32, respectively. This is due to the large surface area and pore volume in In₂O₃-SWCNTs assisting efficient dye-loading that promotes higher efficiency. The obtained results revealed the influence of the addition of CNTs in In₂O₃-based DSSC.

这项研究考虑了碳纳米管（CNTs ）对染料敏化太阳能电池的氧化铟（In ₂ O ₃）的影响，其中碳纳米管是单壁碳纳米管（SWCNTs）和多壁碳纳米管（MWCNTs）。通过使用0.3wt。％的CNT在550℃下退火的溶胶-凝胶法制备薄膜。结果表明薄膜为体心立方相。In ₂ O ₃，In ₂ O ₃ -MWCNT和In ₂ O ₃ -SWCNT的微晶尺寸分别在63、43和30 nm下测量。尽管形态分析表明In ₂ O ₃ -MWCNTs的表面积非常粗糙，但In ₂O ₃ -SWCNT显示出更大的光伏性能。的In _2个ö ₃基于-SWCNTs DSSC表现出与功率转换效率，光电流密度，开路电压，和1.02％的填充因子，5.01毫安/厘米良好光伏性能²，分别0.43 V和0.32。这是由于In ₂ O ₃ -SWCNT中的大表面积和孔体积有助于有效的染料加载，从而提高了效率。获得的结果揭示了在基于In ₂ O ₃的DSSC中添加CNT的影响。