This article describes a combined conventional and digital workflow for fabricating removable partial dentures (RPDs). After scanning the dental cast and RPD framework assembly, artificial teeth and denture base regions were designed using computer-aided design software. The artificial teeth and denture base assembly was milled as a single structure by using a wax disk and then placed on the RPD framework. The artificial teeth were additionally milled from a polymethyl methacrylate disk. Conventional procedures were followed for denture investment until the wax elimination procedure, after which the assembly was replaced with the artificial teeth in the cope of the flasks, and the denture resin material was injected to process the RPD. This technique enabled the RPD to be fabricated in the same form as the design state.

本文介绍了组合的常规和数字工作流程，以制造可移动局部义齿（RPD）。扫描完牙模和RPD框架组件后，使用计算机辅助设计软件设计了假牙和义齿基托区域。通过使用蜡盘将人造牙齿和义齿基托组件研磨成单个结构，然后将其放置在RPD框架上。从聚甲基丙烯酸甲酯盘上另外研磨人造牙齿。遵循常规步骤进行义齿投资，直到除蜡步骤为止，然后在烧瓶上盖中用人造牙替换组件，并注入义齿树脂材料以加工RPD。这项技术使RPD能够以与设计状态相同的形式制造。