当前位置: X-MOL 学术Langmuir › 论文详情
Our official English website, www.x-mol.net, welcomes your feedback! (Note: you will need to create a separate account there.)
Rapid Preparation of TiO2–x and Its Photocatalytic Oxidation for Arsenic Adsorption under Visible Light
Langmuir ( IF 3.9 ) Pub Date : 2020-04-03 , DOI: 10.1021/acs.langmuir.9b02444
Ding Zhao 1, 2, 3, 4 , Baoqiang Xu 1, 2, 3, 4 , Jia Yang 1, 2, 3, 4 , Jian Wu 2, 3, 4 , Weiran Zhai 2, 3, 4 , Bin Yang 1, 2, 3, 4 , Minghui Liu 4
Affiliation  

A rapid preparation method of TiO2–x by thermal treatment using H2TiO3 as the precursor was proposed compared with the static hydrogenation thermal treatment process. Its adsorption properties of arsenic under visible light were explored and investigated as well. Various colors of TiO2–x were prepared and characterized via XRD, TEM, BET, and so on. The results indicate that the method of rapid preparation is feasible. The TiO2–x exhibits a larger particle size that varied from 10 nm to 2 μm, and deeper color products were obtained as the treatment temperature increased from 600 to 900 °C. Light yellow TiO2–x was prepared after increasing the temperature from 600 to 900 °C, Ti4O7 and Ti6O11 with a dark color were formed under a H2 atmosphere at 1500 °C. The arsenic adsorption performances of some samples under visible light were tested, and reveal a high efficiency of TiO2–x in the photocatalytic oxidation arsenic adsorption under visible light, the conversion ratio of As(III) photocatalytic oxidation fluctuates around 2.85 mgAsg–1 h–1. In the absence of visible light, the adsorption capacities for As(III) and As(V) are 3.7 and 42.7 mg/g, respectively, at pH = 3. Under visible light condition, the adsorption capacity of As(III) increases sharply to 15.6 mg/g, which provides the foundation for a new application of TiO2–x in the field of arsenic adsorption.

中文翻译:

可见光下TiO 2– x的快速制备及其对砷的光催化氧化

与静态加氢热处理工艺相比,提出了一种以H 2 TiO 3为前体的热处理快速制备TiO 2– x的方法。还研究了其在可见光下对砷的吸附性能。制备了各种颜色的TiO 2- x,并通过XRD,TEM,BET等进行了表征。结果表明该快速制备方法是可行的。TiO 2– x的粒径更大,从10 nm到2μm不等,并且随着处理温度从600升至900°C,获得了更深的彩色产物。浅黄色TiO 2– x在将温度从600℃升高到900℃之后制备了Ti,在1500℃的H 2气氛下形成了深色的Ti 4 O 7和Ti 6 O 11。测试了一些样品在可见光下的砷吸附性能,发现TiO 2– x在可见光下对光催化氧化砷的吸附效率很高,As(III)光催化氧化的转化率在2.85 mgAsg –1 h左右波动。–1。在没有可见光的情况下,在pH = 3时,As(III)和As(V)的吸附容量分别为3.7和42.7 mg / g。在可见光条件下,As(III)的吸附容量急剧增加。达到15.6 mg / g,这为TiO 2– x在砷吸附领域的新应用奠定了基础。
更新日期:2020-04-03
down
wechat
bug