Synthetic solutions of 2-chlorophenol (2-CP, 1 mM) were treated in an undivided continuous flow electrochemical reactor equipped with boron-doped diamond (BDD) electrodes. The process was conducted at different current densities (j = 0.10, 0.125, and 0.14 A cm⁻²), initial pH (4.0, 7.3, and 9.0), and volumetric flow rate (Q = 0.5, 1.0, and 1.5 L min⁻¹). The results of this study showed that the best operational conditions were: j = 0.14 A cm⁻², pH = 7.3, and y Q = 1 L min⁻¹. Under these operational conditions the degradation and mineralization of 2-CP were, 100% and 96%, respectively, after 6 h of electrolysis time. The by-products were identified by UHPLC. Also, it was found that the electrochemical degradation of 2-chlorophenol follows a pseudo-first order kinetics. Furthermore, these results demonstrate that the electrolysis process employed in this work allows high percentages (96%) of mineralization of 2-CP, a relative low treatment cost ($ 3 MXN/ 2.5 L of synthetic solution), and that the process is applicable to remediate wastewater.

2-氯苯酚（2-CP，1 mM）的合成溶液在配有硼掺杂金刚石（BDD）电极的不间断连续流电化学反应器中进行处理。该工艺在不同的电流密度（传导Ĵ  = 0.10，0.125和0.14厘米^-2），初始pH（4.0，7.3和9.0），和体积流率（Q  = 0.5，1.0，以及1.5升分钟^{- 1}）。这项研究的结果表明，最佳操作条件为：j  = 0.14 A cm ^-2，pH = 7.3，y Q  = 1 L min ^-1。在这些操作条件下，电解6小时后，2-CP的降解和矿化分别为100％和96％。通过UHPLC鉴定副产物。另外，还发现2-氯苯酚的电化学降解遵循拟一级反应动力学。此外，这些结果表明，这项工作所采用的电解工艺可以使2-CP的矿化率很高（96％），处理成本相对较低（3 MXN / 2.5 L合成溶液），并且该工艺是适用的修复废水。