Abstract
This paper is focused on providing a viable solution to wearable antenna performance disconcertment caused by the underlying human body. Direct placement of the antenna on the body yields undesired results owing to the frequency detuning effect. The simplest possible way out is to make use of a metallic reflector. Hence, a reflector backed antenna is presented for 5.8 GHz ISM band with total lateral dimensions of 28 × 28 × 13.58 mm3. The reflector makes use of a conformal high dielectric laminate coated with a thin copper layer owing to which the assembled design achieves low SAR (Specific Absorption Rate). The prototype provides excellent results at the cost of some extra volume occupation in an off-body direction. Another AMC (Artificial Magnetic Conductor) backed technique is followed and implemented separately to have the structural compactness lacking in the former case. The antenna at hand is backed by a 2 × 2 array of AMC unit cells. The overall design dimensions are reduced. The reflector backed design achieves 8.2 dB gain, above 90% efficiency, and 99% bandwidth overlap with the primary antenna. The AMC backed design provides good spectrum coverage from 5.73 to 5.94 GHz with high gain. Free space response, on-body performance, and investigation of SAR analysis of the proposed designs substantiate effective wireless data transfer in body-centric communication.
Funding source: Higher Education Commission, Pakistan
Funding source: Queen Mary University of London
Award Identifier / Grant number: Unassigned
Acknowledgment
Authors would like to thank Higher Education Commission of Pakistan for IRSIP (International Research Support Initiative Program) grant and Queen Mary University of London (QMUL), UK.
-
Author contributions: All the authors have accepted responsibility for the entire content of this submitted manuscript and approved submission.
-
Research funding: None declared.
-
Conflict of interest statement: The authors declare no conflicts of interest regarding this article.
References
[1] C.-E. Guan and T. Fujimoto, “Design of a wideband l-shape fed microstrip patch antenna backed by conductor plane for medical body area network,” Electronics, vol. 9, no. 1, p. 21, 2020.10.3390/electronics9010021Search in Google Scholar
[2] Z. Li, X. Tian, C.-W. Qiu, and J. S. Ho, “Metasurfaces for bioelectronics and healthcare,” Nat. Electron., vol. 4, no. 6, pp. 382–391, 2021. https://doi.org/10.1038/s41928-021-00589-7.Search in Google Scholar
[3] S. M. Saeed, C. A. Balanis, C. R. Birtcher, A. C. Durgun, and H. N. Shaman, “Wearable flexible reconfigurable antenna integrated with artificial magnetic conductor,” IEEE Antenn. Wireless Propag. Lett., vol. 16, pp. 2396–2399, 2017. https://doi.org/10.1109/lawp.2017.2720558.Search in Google Scholar
[4] M. El Atrash, M. A. Abdalla, and H. M. Elhennawy, “A wearable dual-band low profile high gain low sar antenna amc-backed for wban applications,” IEEE Trans. Antenn. Propag., vol. 67, no. 10, pp. 6378–6388, 2019. https://doi.org/10.1109/tap.2019.2923058.Search in Google Scholar
[5] H. R. Raad, A. I. Abbosh, H. M. Al-Rizzo, and D. G. Rucker, “Flexible and compact amc based antenna for telemedicine applications,” IEEE Trans. Antenn. Propag., vol. 61, no. 2, pp. 524–531, 2012.10.1109/TAP.2012.2223449Search in Google Scholar
[6] L. Kurra, M. P. Abegaonkar, A. Basu, and S. K. Koul, “Fss properties of a uniplanar ebg and its application in directivity enhancement of a microstrip antenna,” IEEE Antenn. Wireless Propag. Lett., vol. 15, pp. 1606–1609, 2016. https://doi.org/10.1109/lawp.2016.2518299.Search in Google Scholar
[7] P. Nepa and H. Rogier, “Wearable antennas for off-body radio links at vhf and uhf bands: Challenges, the state of the art, and future trends below 1 ghz,” IEEE Antenn. Propag. Mag., vol. 57, no. 5, pp. 30–52, 2015. https://doi.org/10.1109/map.2015.2472374.Search in Google Scholar
[8] R. Yahya, M. Kamarudin, and N. Seman, “Effect of rainwater and seawater on the permittivity of denim jean substrate and performance of uwb eye-shaped antenna,” IEEE Antenn. Wireless Propag. Lett., vol. 13, pp. 806–809, 2014. https://doi.org/10.1109/lawp.2014.2318756.Search in Google Scholar
[9] A. Y. Ashyap, S. H. B. Dahlan, Z. Z. Abidin et al.., “An overview of electromagnetic band-gap integrated wearable antennas,” IEEE Access, vol. 8, pp. 7641–7658, 2020. https://doi.org/10.1109/access.2020.2963997.Search in Google Scholar
[10] A. Alemaryeen and S. Noghanian, “On-body low-profile textile antenna with artificial magnetic conductor,” IEEE Trans. Antenn. Propag., vol. 67, no. 6, pp. 3649–3656, 2019. https://doi.org/10.1109/tap.2019.2902632.Search in Google Scholar
[11] G.-P. Gao, C. Yang, B. Hu, R.-F. Zhang, and S.-F. Wang, “A wide-bandwidth wearable all-textile pifa with dual resonance modes for 5 ghz wlan applications,” IEEE Trans. Antenn. Propag., vol. 67, no. 6, pp. 4206–4211, 2019. https://doi.org/10.1109/tap.2019.2905976.Search in Google Scholar
[12] A. Y. Ashyap, Z. Z. Abidin, S. H. Dahlan et al.., “Compact and low-profile textile ebg-based antenna for wearable medical applications,” IEEE Antenn. Wireless Propag. Lett., vol. 16, pp. 2550–2553, 2017. https://doi.org/10.1109/lawp.2017.2732355.Search in Google Scholar
[13] C. Mendes and C. Peixeiro, “On-body transmission performance of a novel dual-mode wearable microstrip antenna,” IEEE Trans. Antenn. Propag., vol. 66, no. 9, pp. 4872–4877, 2018. https://doi.org/10.1109/tap.2018.2851669.Search in Google Scholar
[14] S. Velan, E. F. Sundarsingh, M. Kanagasabai et al.., “Dual-band ebg integrated monopole antenna deploying fractal geometry for wearable applications,” IEEE Antenn. Wireless Propag. Lett., vol. 14, pp. 249–252, 2014.10.1109/LAWP.2014.2360710Search in Google Scholar
[15] B. Mandal and S. K. Parui, “A miniaturized wearable button antenna for wi-fi and wi-max application using transparent acrylic sheet as substrate,” Microw. Opt. Technol. Lett., vol. 57, no. 1, pp. 45–49, 2015. https://doi.org/10.1002/mop.28781.Search in Google Scholar
[16] H. Xiaomu, S. Yan, and G. A. Vandenbosch, “Wearable button antenna for dual-band wlan applications with combined on and off-body radiation patterns,” IEEE Trans. Antenn. Propag., vol. 65, no. 3, pp. 1384–1387, 2017. https://doi.org/10.1109/tap.2017.2653768.Search in Google Scholar
[17] Y. Li, Z. Lu, and L. Yang, “Cpw-fed slot antenna for medical wearable applications,” IEEE Access, vol. 7, pp. 42 107–142 112, 2019. https://doi.org/10.1109/access.2019.2908199.Search in Google Scholar
[18] A. Abdu, H.-X. Zheng, H. A. Jabire, and M. Wang, “Cpw-fed flexible monopole antenna with h and two concentric c slots on textile substrate, backed by ebg for wban,” Int. J. RF Microw. Computer-Aided Eng., vol. 28, no. 7, p. e21505, 2018. https://doi.org/10.1002/mmce.21505.Search in Google Scholar
[19] A. Iqbal, A. J. Alazemi, and N. K. Mallat, “Slot-dra-based independent dual-band hybrid antenna for wearable biomedical devices,” IEEE Access, vol. 7, pp. 184 029–184 037, 2019. https://doi.org/10.1109/access.2019.2960443.Search in Google Scholar
[20] A. Y. Ashyap, Z. Z. Abidin, S. H. Dahlan et al.., “Highly efficient wearable cpw antenna enabled by ebg-fss structure for medical body area network applications,” IEEE Access, vol. 6, pp. 77 529–577 541, 2018. https://doi.org/10.1109/access.2018.2883379.Search in Google Scholar
[21] B. S. Cook and A. Shamim, “Utilizing wideband amc structures for high-gain inkjet-printed antennas on lossy paper substrate,” IEEE Antenn. Wireless Propag. Lett., vol. 12, pp. 76–79, 2013. https://doi.org/10.1109/lawp.2013.2240251.Search in Google Scholar
[22] Z. H. Jiang, D. E. Brocker, P. E. Sieber, and D. H. Werner, “A compact, low-profile metasurface-enabled antenna for wearable medical body-area network devices,” IEEE Trans. Antenn. Propag., vol. 62, no. 8, pp. 4021–4030, 2014. https://doi.org/10.1109/tap.2014.2327650.Search in Google Scholar
[23] Body Tissue Dielectric Parameters. Available at: https://www.fcc.gov/general/body-tissue-dielectric-parameters [accessed: April 17, 2020].Search in Google Scholar
[24] G.-P. Gao, B. Hu, S.-F. Wang, and C. Yang, “Wearable circular ring slot antenna with ebg structure for wireless body area network,” IEEE Antenn. Wireless Propag. Lett., vol. 17, no. 3, pp. 434–437, 2018.10.1109/LAWP.2018.2794061Search in Google Scholar
[25] S. Kim, Y.-J. Ren, H. Lee, A. Rida, S. Nikolaou, and M. M. Tentzeris, “Monopole antenna with inkjet-printed ebg array on paper substrate for wearable applications,” IEEE Antenn. Wireless Propag. Lett., vol. 11, pp. 663–666, 2012. https://doi.org/10.1109/lawp.2012.2203291.Search in Google Scholar
[26] A. Alemaryeen and S. Noghanian, “Crumpling effects and specific absorption rates of flexible amc integrated antennas,” IET Microw., Antennas Propag., vol. 12, no. 4, pp. 627–635, 2017.10.1049/iet-map.2017.0652Search in Google Scholar
[27] J. Tak, Y. Hong, and J. Choi, “Textile antenna with ebg structure for body surface wave enhancement,” Electron. Lett., vol. 51, no. 15, pp. 1131–1132, 2015. https://doi.org/10.1049/el.2015.1022.Search in Google Scholar
[28] K. Masrakin, H. A. Rahim, P. J. Soh et al.., “Assessment of worn textile antennas’ exposure on the physiological parameters and well-being of adults,” IEEE Access, vol. 7, pp. 98 946–998 958, 2019. https://doi.org/10.1109/access.2019.2928343.Search in Google Scholar
[29] IEEE recommended practice for determining the peak spatial-average specific absorption rate (SAR) in the human head from wireless communications devices: measurement techniques.” in IEEE Std 1528-2013 (Revision of IEEE Std 1528-2003) Redline, 2013, pp. 1–500.Search in Google Scholar
[30] S. Jayant, G. Srivastava, and R. Purwar, “Bending and sar analysis on uwb wearable mimo antenna for on-arm wban applications,” Frequenz, vol. 75, nos 5-6, pp. 177–189, 2021. https://doi.org/10.1515/freq-2020-0105.Search in Google Scholar
[31] J. Trajkovikj and A. K. Skrivervik, “Diminishing sar for wearable uhf antennas,” IEEE Antenn. Wireless Propag. Lett., vol. 14, pp. 1530–1533, 2014.10.1109/LAWP.2014.2374423Search in Google Scholar
© 2022 Walter de Gruyter GmbH, Berlin/Boston
