Abstract
Some features of the magnetization reversal of Fe–3% Si sheet electrotechnical steel with different degrees of texturing have been studied. It was revealed that stripe samples, even with the very sharp edge texture {110}〈001〉 have a nonuniform magnetic permeability along the length of the stripe. It is established that this nonuniformity is due to the different sizes of crystallites and different orientations of their magnetization Is with respect to the rolling direction of the studied samples. It is demonstrated that, to decrease the magnetic losses of anisotropic electrotechnical steel via the artificial reduction of its domain structure, it is reasonable to deposit locally strained zones not onto the entire sample surface but only onto areas with the maximum magnetic permeability.
Similar content being viewed by others
REFERENCES
N. A. Skulkina, A. K. Mazeeva, P. A. Kuznetsov, V. I. Chekis, N. D. Denisov, and E. S. Nekrasov, “Influence of polymer coating on the magnetic characteristics of ribbon of an amorphous cobalt-based alloy in the as-quenched state,” Phys. Met. Metallogr. 121, No. 2, 128–134 (2020).
N. A. Skulkina, O. A. Ivanov, A. K. Mazeeva, P. A. Kuznetsov, V. I. Chekis, and N. D. Denisov, “Temperature of the formation of a protective polymer coating and the magnetic properties of cobalt-based amorphous alloys,” Phys. Met. Metallogr. 120, No. 6, 615–621 (2019).
V. V. Druzhinin, Magnetic Properties of Electrotechnical Steel (Energiya, Moscow, 1974) [in Russian].
P. Rauschera, J. Hauptmann, and E. Beyer, “Laser scribing of grain oriented electrical steel under the aspect of industrial utilization using high power laser beam sources,” Phys. Proc. 41, 312–318 (2013).
I. Petryshynets, V. Puchyґ, F. Kovaґc, and M. Sebek, “Effect of laser scribing on soft magnetic properties of conventional grain-oriented silicon steel,” Acta Phys. Pol. 131, 777–779 (2017).
A. G. Grigor’yants, A. Yu. Shishov, and V. A. Funtikov, “Technology of local laser processing of electrical anisotropic steel with direct diode lasers,” Tekhnol. Mashinost., No. 8, 37–42 (2017).
J. Zhang, Z. Chen, Z. Li, W. Zhang, J. Long, and F. Chen, “Morphology and magnetic properties of grain-oriented steel scribed using different picosecond lasers,” Appl. Phys. A 126, 327 (2020). https://doi.org/10.1007/s00339-020-3438-3
V. F. Tiunov, B. K. Sokolov, and V. V. Gubernatorov, “Influence of deformed bands on the dynamic behavior of the domain structure and magnetic losses in Fe–3 wt % Si crystals,” Fiz. Met. Metalloved., No. 11, 79–84 (1991).
V. F. Tiunov and G. S. Korzunin, “Control of the inhomogeneity of the magnetic permeability of sheet anisotropic electrical steel,” Defektoskopiya, No. 3, 46–49 (2019).
V. F. Tiunov, “On the influence of the nonuniformity of remagnetization of Fe–3% Si anisotropic electrical steel on magnetic loss in rotating magnetic fields,” Phys. Met. Metallogr. 119, No. 9, 825–830 (2018).
K. J. Overshott and M. G. Blundell, “Power loss, domain wall motion and flux density of neighbouring grains in grain-oriented 3% silicon-iron,” IEEE Trans. Mag. 20, 1551–1553 (1984).
I. F. Bukhanova, V. V. Divinskii, and V. M. Zhuravel’, “Laser processing of magnetic core plates of power transformers,” Elektrotekhnika, No. 1, 39–42 (2004).
R. B. Puzhevich and L. S. Karenina, “Insulating-coating flaws formed during laser processing of an electric anisotropic steel and their effects on magnetic properties,” Russ. J. Nondestr. Test. 47, 232–235 (2011).
R. I. Yanus, “On sheet inhomogeneity of the magnetic properties of electrical iron,” Fiz. Met. Metalloved., No. 1, 84–91 (1955).
B. K. Sokolov, Yu. N. Dragoshanskii, V. S. Matveeva, M. B. Tsirlin, F. V. Mineev, and R. B. Puzhevich, “Inhomogeneity of magnetic properties of an anisotropic electrical steel and specific features of dislocation structures,” Russ. J. Nondestr. Test. 40, 768–775 (2004).
V. F. Tiunov, V. A. Zaikova, and Ya. S. Shur, “Dynamics of 180-degree domain walls and electromagnetic losses in Fe–3% Si crystals,” Fiz. Met. Metalloved. 47, 539–548 (1979).
H. Williams, W. Shockley, and C. Kittel, “Investlgation of the domain wall motion velocity,” Phys. Rev. 80, 1090–1102 (1950).
V. A. Zaikova, I. E. Startseva, and B. N. Filippov, Domain Structure and Magnetic Properties of Electrotechnical Steels (Nauka, Moscow, 1982) [in Russian].
R. H. Pry and C. P. Bean, “Calculation of the energy loss in magnetic sheet materials using a domain model,” J. Appl. Phys. 29, 532–533 (1958).
V. F. Tiunov, “Measuring device for continuous testing of magnetic losses in coiled electrical steel,” Russ. J. Nondestr. Test. 40, 269–272 (2004).
Funding
This study was carried out within the state task from the Ministry of Science and Higher Education of Russia (project “Magnet”, no. AAAA-A18-118020290129-5).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by E. Glushachenkova
Rights and permissions
About this article
Cite this article
Tiunov, V.F. On Nonuniformity in the Magnetization Reversal of Electrotechnical Steel in Linearly Polarized Magnetic Fields. Phys. Metals Metallogr. 122, 527–532 (2021). https://doi.org/10.1134/S0031918X21060119
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S0031918X21060119