Skip to main content
SpringerLink
Log in

The Effect of Fillers on the Properties of Uncured Sealants Based on Nitrile Butadiene Rubber

  • Published:
Polymer Science, Series D Aims and scope Submit manuscript

Abstract

The results of studies of the effect of fillers, such as chalk of MTD-2 and Omyakarb 5KA grades and kaolin, on the cohesive and adhesive strength and on the viscosity of uncured sealants based on nitrile butadiene rubber are discussed. The effect of external factors, such as water and high temperature, on the adhesive and strength properties of sealants was studied. It is shown that the use of MTD-2 chalk as a filler makes it possible to use nitrile-butadiene-rubber-based uncured sealants as an adhesive layer in the repair of PVC roofing membranes.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1.
Fig. 2.
Fig. 3.
Fig. 4.
Fig. 5.
Fig. 6.

Similar content being viewed by others

REFERENCES

  1. A. A. Stytsenkov, A. R. Akhmedgoraeva, R. Yu. Galimzyanova, and Yu. N. Khakimullin, “Types of roll roofing materials, the size of the Russian market, and the ecological state,” Polim. Stroit.: Nauchn. Internet-Zh. 1 (7), 73–82 (2019).

  2. S. S. Orlova and Sh. A. Aligadzhiev, “Advantages and disadvantages of roofing materials for buildings and structures,” in Modern Science: Theoretical and Practical View: Proc. Int. Sci.-Pract. Conf. (Ufa, 2015), pp. 258–260.

  3. I. V. Imamutdinov, R. Yu. Galimzyanova, and Yu. N. Khakimullin, “Elastomer-based sealants,” Vestn. Kazan. Tekhnol. Univ. 18 (6), 69–74 (2015).

  4. T. C. Marrana, J. D. Silvestre, J. Brito, and R. Gomes, “Lifecycle cost analysis of flat roofs of buildings,” J. Constr. Eng. Manage. 143 (6) (2017).

  5. J. Conceição, B. Poçã, J. Brito, I. Flores-Colen, and A. Castelo, “Data analysis of inspection, diagnosis, and rehabilitation of flat roofs,” J. Perform. Constr. Facil. 33 (1), 1–12 (2019).

  6. M. A. Zagorodnikova, V. P. Yartsev, and V. G. Rupyshev, “Strength and durability of roofing PVC membranes in the conditions of climate impacts,” Adv. Mater. Technol., No. 2, 041–047 (2019).

  7. M. Sharma, M. Whaley, J. Chamberlain, et al., “Evaluation of Thermochromic Elastomeric Roof Coatings for Low-Slope Roofs,” Energy Build. 155, 459–466 (2017).

  8. M. Apollo and A. Siemaszko, “The selected roof covering technologies in the aspect of their life cycle costs,” Open Eng. 8 (1), 478–483 (2018). https://doi.org/10.1515/eng-2018-0053

  9. D. K. Swarnkar, “Green retrofitting of existing buildings refereed using cool roof technoligy,” Int. J. Sci. Res. Growth 2 (2), 29–35 (2017).

  10. M. S. Mammadov, F. R. Khankisiyeva, S. J. Mammadov, A. A. Garibov, and N. R. Mehdiyeva, “The influence of irradiation and temperature to the nature of crosslinking in isoprene nitrile elastomer,” Univers. J. Chem 3 (2), 49–54 (2015).

  11. J. G. Lopes and J. R. Correia, “Reparability of aged PVC waterproofing membranes: Effect of joining method,” J. Build. Eng. 33 (7) (2020). https://doi.org/10.1016/j.jobe.2020.101569

  12. R. Yu. Galimzyanova, M. S. Lisanevich, Yu. N. Khakimullin, and D. L. Poteshkin, “Non-drying elastomer based sealants. Review,” Klei, Germetiki, Tekhnol., No. 5, 38–43 (2017).

  13. M. S. Perova, Candidate’s Dissertation in Engineering (Kazan, 2011).

  14. L. I. Murtazina, A. R. Garifullin, I. A. Nukul’tsev, R. Yu. Galimzyanova, and Yu. N. Khakimullin, “Effect of technological additives on the properties of non-curable sealants based on ethylene propylene diene rubber,” Izv. Kazan. Gos. Arkhit.-Stroit. Univ. 31 (1), 134–140 (2015).

  15. L. G. Gerasimova, E. S. Shchukina, M. V. Maslova, and Yu. G. Kiselev, “Composite fillers for adhesives and sealants,” Klei, Germetiki, Tekhnol., No. 8, 2–6 (2019).

  16. L. I. Murtazina, A. R. Garifullin, I. A. Nikul’tsev, R. F. Fatkhullin, R. Yu. Galimzyanova, and Yu. N. Khakimullin, “The influence of calcium carbonate on the properties of noncuring sealants based on ethylene propylene diene monomer rubber and thermoplastics,” Polym. Sci., Ser. D 8, 199–202 (2015).

Download references

Author information

Authors and Affiliations

  1. Kazan National Research Technological University, 420015, Kazan, Russia

    A. R. Akhmedgoraeva, A. A. Stytsenkov, R. Yu. Galimzyanova & Yu. N. Khakimullin

Authors
  1. A. R. Akhmedgoraeva
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. A. A. Stytsenkov
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. R. Yu. Galimzyanova
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. Yu. N. Khakimullin
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to R. Yu. Galimzyanova.

Ethics declarations

The authors declare that they have no conflict of interest.

Additional information

Translated by G. Levit

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Akhmedgoraeva, A.R., Stytsenkov, A.A., Galimzyanova, R.Y. et al. The Effect of Fillers on the Properties of Uncured Sealants Based on Nitrile Butadiene Rubber. Polym. Sci. Ser. D 14, 213–217 (2021). https://doi.org/10.1134/S1995421221020027

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1134/S1995421221020027

Keywords:

Search

Navigation