Abstract
In this paper, confined explosions of HMX-based aluminized explosives in a spherical chamber are studied. The effects of aluminum particles on the afterburning reaction and explosive performance are obtained by changing the size of the particles and the gas environment. The results show that the concentration of oxygen in air is not sufficient to support complete combustion of aluminum particles. The estimated oxidation rate of aluminum particles is 87–93%, and it tends to decrease with increasing particle size. Part of aluminum particles oxidize with detonation products, and the reaction can last for hundreds of microseconds. However, the degree of oxidation between the large-sized aluminum particles and detonation products is small. A new method is used to estimate the initial energy of detonation by observing the time difference between sensing the initial light and the pressure wave. This method leads to a conclusion that some of the aluminum particles are oxidized during detonation and provide additional energy to the primary blast wave. Small micron-sized aluminum particles in the range of 48.9 nm to 46.7 \(\mu\)m extend the duration of the fireball.
Similar content being viewed by others
REFERENCES
J. R. Carney, J. M. Lightstone, T. P. McGrath II, and R. J. Lee, “Fuel-Rich Explosive Energy Release: Oxidizer Concentration Dependence," Propell., Explos., Pyrotech. 34 (4), 331–339 (2009).
K. L. McNesby, B. E. Homan, J. J. Ritter, et al., “Afterburn Ignition Delay and Shock Augmentation in Fuel Rich Solid Explosives," Propell., Explos., Pyrotech. 35, 57–65 (2010).
W. A. Trzciński and J. Paszula, “Confined Explosions of High Explosives," J. Tech. Phys. 41 (4), 453–470 (2000).
P. P. Vadhe, R. B. Pawar, R. K. Sinha, et al., “Cast Aluminized Explosives (Review)," Fiz. Goreniya Vzryva 44 (4), 98–115 (2008) [Combust., Expl., Shock Waves 44 (4), 461–477 (2008)].
P. J. Haskins, M. D. Cook, and R. I. Briggs, “The Effect of Additives on the Detonation Characteristics of a Liquid Explosive," in Proc. 12th APS Topical Group Meeting on Shock Compression of Condensed Matter, Atlanta, 2001, pp. 890–893.
M. A. Trunov, M. Schoenitz, X. Y. Zhu, and E. L. Dreizin, “Effect of Polymorphic Phase Transformations in Al2O3Film on Oxidation Kinetics of Aluminum Powders," Combust. Flame140, 310–318 (2005).
V. I. Levitas, “Burn Time of Aluminum Nanoparticles: Strong Effect of the Heating Rate and Melt-Dispersion Mechanism," Combust. Flame 156 (2), 543–546 (2009).
J. M. Peuker, H. Krier, and N. Glumac, “Particle Size and Gas Environment Effects on Blast and Overpressure Enhancement in Aluminized Explosives," Proc. Combust. Inst. 34, 2205–2212 (2013).
W. K. Lewis, C. G. Rumchik, P. B. Broughton, and C. M. Lindsay, “Time-Resolved Spectroscopic Studies of Aluminized Explosives: Chemical Dynamics and Apparent Temperatures," J. Appl. Phys.111, 014903 (2012).
V. Tanguay, S. Goroshin, A. J. Higgins, and F. Zhang, “Aluminum Particle Combustion in High-Speed Detonation Products," Combust. Sci. Technol. 181, 670–693 (2009).
T. Bazyn, H. Krier, and N. Glumac, “Evidence for the Transition from the Diffusion-Limit in Aluminum Particle Combustion," Proc. Combust. . 31, 2021–2028 (2007).
K. Park, D. Lee, A. Rai, et al., “Size-Resolved Kinetic Measurements of Aluminum Nanoparticle Oxidation with Single Particle Mass Spectrometry," Phys. Chem. B 109, 7290–7299 (2005).
W. A. Trzciński, S. Cudziło, J. Paszula, and J. Callaway, “Study of the Effect of Additive Particle Size on Non-Ideal Explosive Performance," Propell., Explos., Pyrotech. 33 (3), 227–235 (2008).
L. Maiz, W. A. Trzciński, and J. Paszula, “Investigation of Fireball Temperatures in Confined Thermobaric Explosions," Propell., Explos., Pyrotech. 42 (2), 142–148 (2017).
K. Chen, W. Xiao, Z. W. Han, et al., “Effect of Aluminum Particle Size on the Explosion Parameters of HMX-Based Thermobaric Explosives in Confined Space," Chin. J. Explos. Propell. (2020); DOI: 10.14077/j.issn.1007-7812.201909018.
L. Maiz, W. A. Trzciński, M. Szala, and J. Paszula, “Studies of Confined Explosions of Composite Explosives and Layered Charges," Cent. Eur. J. Energ. Mater. 13, 957–977 (2016).
L. Maiz, W. A. Trzciński, and M. Szala, “Preparation and Testing of Thermobaric Composites," in Proc. 18th Seminar on New Trends in Research of Energetic Materials (Pardubice, Czech Republic, 2015), pp. 705–715.
A. Rai, K. Park, L. Zhou, and M. R. Zachariah, “Understanding the Mechanism of Aluminum Nanoparticle Oxidation," Combust. Theory Modell. 10 (5), 843–859 (2006).
W. A. Trzciński, K. Barcz, J. Paszula, and S. Cudziło, “Investigation of Blast Performance and Solid Residues for Layered Thermobaric Charges," Propell., Explos., Pyrotech.39, 40–50 (2014).
S. Goroshin, J. Mamen, A. Higgins, et al., “Emission Spectroscopy of Flame Fronts in Aluminum Suspensions," Proc. Combust. Inst.31, 2011–2019 (2007).
J. B. Deng, Study of the Damage Effects of Four Thermobaric Explosives (Nanjing University of Science & Technology, 2013) [In chinese].
N. H. Yen and L. Y. Wang, “Reactive Metals in Explosives," Propell., Explos., Pyrotech. 37, 143–155 (2012).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Fizika Goreniya i Vzryva, 2021, Vol. 57, No. 2, pp. 104–115.https://doi.org/10.15372/FGV20210211.
Rights and permissions
About this article
Cite this article
Xiao, W., Chen, K., Yang, MF. et al. Effects of the Particle Size and Gas Environment on Afterburning Reactions and Explosion Performance of Aluminized HMX-Based Explosives. Combust Explos Shock Waves 57, 222–231 (2021). https://doi.org/10.1134/S0010508221020118
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S0010508221020118