Skip to main content
Log in

Experimental Study on the Enhanced Thermal Performance of Two-Phase Closed Thermosyphon Using Mechanical and Chemical Treated MWCNTs Nanofluids

  • Original Article
  • Published:
Microgravity Science and Technology Aims and scope Submit manuscript

Abstract

Nowadays the two-phase closed thermosyphon (TPCT) has been widely used as an important heat transfer medium for passive cooling systems. Since the enhancement of the performance of electronic device releases a considerable amount of heat, the development of working fluids which can improve thermal performance of the TPCT is necessary. In this experiment, two different type of MWCNT nanofluids were successfully made by using ball-mill process and alkaline treatment. The morphological and structural analysis were conducted by using transmission electron microscope (TEM), fourier-transform infrared spectroscopy (FT-IR). Also thermal conductivity of modified MWCNT nanofluids were investigated by introducing transient hot wire method. The results of TEM, FT-IR and thermal conductivity showed that the MWCNTs were successfully functionalized as well as had higher thermal conductivity. The TPCT was fabricated with copper tube and total length of the TPCT is 700mm, in which the evaporator section, the adiabatic section and the condenser section are 150mm, 400mm, and 150mm, respectively. The experiment of the thermal performance of the TPCT was evaluated by introducing RMS value of the temperature of the evaporation section, thermal resistance and heat transfer coefficient at five different filling ratios, 10%, 30%, 50% and 70% by ratcheting up heat loads in five levels, 5W, 8W, 10W, 13W and 15W. The overall results showed that the both of modified MWCNT nanofluids can decrease thermal resistance and increase the heat transfer coefficient, especially at 10% filling ratio with 8W. M-CNT nanofluid can even enhance the thermal performance of TPCT at 30% filling ratio with all heat loads.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14

Similar content being viewed by others

Abbreviations

C-CNT:

Chemical treated MWCNT

DW:

Distilled water

h:

Heat transfer coefficient [W/m2°C]

M-CNT:

Mechanical treated MWCNT

Q:

Watt [W]

R:

Thermal resistance [°C/W]

T c :

Condenser temperature [°C]

T e :

Evaporator temperature [°C]

T m :

Mean temperature [°C]

T r :

Room temperature [°C]

wt%:

Weight percentage

References

  • Abhat, A.: Performance studies of a finned heat pipe latent thermal energy storage system. In Sun: Mankind's Future Source of Energy (pp. 541-546) Pergamon (1978)

  • Ahn, J.H., Shin, H.S., Kim, Y.J., Chung, H.: Structural modification of carbon nanotubes by various ball milling. J. Alloys Compd. 434, 428–432 (2007)

    Article  Google Scholar 

  • Akbarzadeh, A., Wadowski, T.: Heat pipe-based cooling systems for photovoltaic cells under concentrated solar radiation. Appl. Therm. Eng. 16(1), 81–87 (1996)

    Article  Google Scholar 

  • Choi, S.U.S.: Enhancing thermal conductivity of fluids with nanoparticles. ASME FED 231, 99e105 (1995)

    Google Scholar 

  • Choi, T.J., Kim, S.H., Jang, S.P., Lin, L., Kedzierski, M.A.: Aqueous nanofluids containing paraffin-filled MWCNTs for improving effective specific heat and extinction coefficient. Energy 210, 118523 (2020)

    Article  Google Scholar 

  • Contreras, E.M.C., Oliveira, G.A., Bandarra Filho, E.P.: Experimental analysis of the thermohydraulic performance of graphene and silver nanofluids in automotive cooling systems. Int. J. Heat Mass Transf. 132, 375–387 (2019)

    Article  Google Scholar 

  • Delpeux, S., Szostak, K., Frackowiak, E., Béguin, F.: An efficient two-step process for producing opened multi-walled carbon nanotubes of high purity. Chem. Phys. Lett. 404(4–6), 374–378 (2005)

    Article  Google Scholar 

  • Dobak III, J. D.: U.S. Patent No. 6,364,899. Washington, DC: U.S. Patent and Trademark Office (2002)

  • Huminic, G., Huminic, A.: Heat transfer characteristics of a two-phase closed thermosyphons using nanofluids. Exp. Therm. Fluid Sci. 35(3), 550–557 (2011)

    Article  Google Scholar 

  • Khandekar, S., Joshi, Y.M., Mehta, B.: Thermal performance of closed two-phase thermosyphon using nanofluids. Int. J. Therm. Sci. 47(6), 659–667 (2008)

    Article  Google Scholar 

  • Kim, S.D., Kim, J.W., Im, J.S., Kim, Y.H., Lee, Y.S.: A comparative study on properties of multi-walled carbon nanotubes (MWCNTs) modified with acids and oxyfluorination. J. Fluorine Chem. 128(1), 60–64 (2007)

    Article  Google Scholar 

  • Lide, D.R. (Ed.).: CRC handbook of chemistry and physics (Vol. 85). CRC press (2004)

  • Liu, H., Todreas, N.E., Driscoll, M.J.: An experimental investigation of a passive cooling unit for nuclear plant containment. Nucl. Eng. Des. 199(3), 243–255 (2000)

    Article  Google Scholar 

  • Mangini, D., Mameli, M., Georgoulas, A., Araneo, L., Filippeschi, S., Marengo, M.: A pulsating heat pipe for space applications: Ground and microgravity experiments. Int. J. Therm. Sci. 95, 53–63 (2015)

    Article  Google Scholar 

  • Munkhbayar, B., Nine, M.J., Jeoun, J., Bat-Erdene, M., Chung, H., Jeong, H.: Influence of dry and wet ball milling on dispersion characteristics of the multi-walled carbon nanotubes in aqueous solution with and without surfactant. Powder Technol. 234, 132–140 (2013)

    Article  Google Scholar 

  • Nasiri, A., Shariaty-Niasar, M., Rashidi, A.M., Khodafarin, R.: Effect of CNT structures on thermal conductivity and stability of nanofluid. Int. J. Heat Mass Transf. 55(5–6), 1529–1535 (2012)

    Article  Google Scholar 

  • Nguyen-Chi, H., Groll, M.: Entrainment or flooding limit in a closed two-phase thermosyphon. J. Heat Recovery Syst. 1(4), 275–286 (1981)

    Article  Google Scholar 

  • Noie, S.H., Heris, S.Z., Kahani, M., Nowee, S.M.: Heat transfer enhancement using Al2O3/water nanofluid in a two-phase closed thermosyphon. Int. J. Heat Fluid Flow 30(4), 700–705 (2009)

    Article  Google Scholar 

  • Paramatthanuwat, T., Boothaisong, S., Rittidech, S., Booddachan, K.: Heat transfer characteristics of a two-phase closed thermosyphon using de ionized water mixed with silver nano. Heat Mass Transf. 46(3), 281–285 (2010)

    Article  Google Scholar 

  • Peterson, G.P., Duncan, A. B., Weichold, M.H.: Experimental investigation of micro heat pipes fabricated in silicon wafers (1993)

  • Peterson, G.P., Fletcher, L.S.: U.S. Patent No. 5,417,686. Washington, DC: U.S. Patent and Trademark Office (1995)

  • Rao, Z., Wang, S., Wu, M., Lin, Z., Li, F.: Experimental investigation on thermal management of electric vehicle battery with heat pipe. Energ. Conver. Manage. 65, 92–97 (2013)

    Article  Google Scholar 

  • Reay, D., Kew, P., McGlen, R.: Heat pipes theory, design and applications. Elsevier, Amsterdam (2014)

    Google Scholar 

  • Rehman, H., Nine, M.J., Afrianto, H., Kim, J.H., Chung, H., Jeong, H.: Experimental and Numerical Analysis of Convective Heat Transfer of Alumina Nanofluids Under Laminar Flow Regime. J. Comput. Theor. Nanosci. 10(10), 2305–2311 (2013)

    Article  Google Scholar 

  • Riehl, R.R., Dutra, T.: Development of an experimental loop heat pipe for application in future space missions. Appl. Therm. Eng. 25(1), 101–112 (2005)

    Article  Google Scholar 

  • Said, Z., Assad, M.E.H., Hachicha, A.A., Bellos, E., Abdelkareem, M.A., Alazaizeh, D.Z., Yousef, B.A.: Enhancing the performance of automotive radiators using nanofluids. Renew. Sust. Energ. Rev. 112, 183–194 (2019)

    Article  Google Scholar 

  • Shim, J.W., Park, S.J., Ryu, S.K.: Effect of modification with HNO3 and NaOH on metal adsorption by pitch-based activated carbon fibers. Carbon 39(11), 1635–1642 (2001)

    Article  Google Scholar 

  • Shukla, K.N.: Heat pipe for aerospace applications—an overview. J. Electron. Cooling Therm. Control 5(01), 1 (2015)

    Article  Google Scholar 

  • Stephan, P.C., Busse, C.A.: Analysis of the heat transfer coefficient of grooved heat pipe evaporator walls. Int. J. Heat Mass Transf. 35(2), 383–391 (1992)

    Article  Google Scholar 

  • Wang, Z., Yao, F.: Investigation on Transient Characteristics of Heat Pipe with Re-Entrant Grooved Wick. Microgravity Sci. Technol. 32, 521–529 (2020)

    Article  Google Scholar 

  • Wang, Y., Zou, C., Li, W., Zou, Y., Huang, H.: Improving stability and thermal properties of TiO2 nanofluids by supramolecular modification: high energy efficiency heat transfer medium for data center cooling system. Int. J. Heat Mass Transf. 156, 119735 (2020)

    Article  Google Scholar 

  • Xue, H.S., Fan, J.R., Hu, Y.C., Hong, R.H., Cen, K.F.: The interface effect of carbon nanotube suspension on the thermal performance of a two-phase closed thermosyphon. J. Appl. Phys. 100(10), 104909 (2006)

    Article  Google Scholar 

  • Yang, S.Y., Ma, C.C.M., Teng, C.C., Huang, Y.W., Liao, S.H., Huang, Y.L., Chiou, K.C.: Effect of functionalized carbon nanotubes on the thermal conductivity of epoxy composites. Carbon 48(3), 592–603 (2010)

    Article  Google Scholar 

  • Yarin, L.P., Mosyak, A., Hetsroni, G.: Fluid Flow, Heat Transfer and Boiling in Micro-Channels, Springer pp. 7 (2009)

  • Yu, W., France, D.M., Routbort, J.L., Choi, S.U.: Review and comparison of nanofluid thermal conductivity and heat transfer enhancements. Heat Transf. Eng. 29(5), 432–460 (2008)

    Article  Google Scholar 

  • Zhang, H., Li, G., Chen, L., Man, G., Miao, J., Ren, X., Huo, Y.: Development of Flat-Plate Loop Heat Pipes for Spacecraft Thermal Control. Microgravity Sci. Technol. 31(4), 435–443 (2019)

    Article  Google Scholar 

Download references

Acknowledgements

This research was supported by Basic Science Research Program through the National Research Foundation of Korea (NRF) funded by the Ministry of Science, ICT and future Planning (No. 2017R1A2B4007620).

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Hyomin Jeong.

Additional information

Publisher’s Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Baek, S., Lee, A., Lee, S. et al. Experimental Study on the Enhanced Thermal Performance of Two-Phase Closed Thermosyphon Using Mechanical and Chemical Treated MWCNTs Nanofluids. Microgravity Sci. Technol. 33, 30 (2021). https://doi.org/10.1007/s12217-021-09872-w

Download citation

  • Received:

  • Accepted:

  • Published:

  • DOI: https://doi.org/10.1007/s12217-021-09872-w

Keywords

Navigation