Skip to main content
Log in

Design and optimization of a microwave photonic filter exploiting differential mode group delay of a multi-mode fiber

  • Regular Paper
  • Published:
Optical Review Aims and scope Submit manuscript

Abstract

A reconfigurable and application-specific tunable microwave photonic filter having finite impulse response is proposed. The filter exploits the differential mode group delays of linearly polarized modes in a multi-mode fiber to achieve single and multiple high-frequency passband response. The filter taps are realized using a single continuous wave laser source and differential delays among modes that are propagated through a single spool of graded index multi-mode fiber. Depending upon the application requirement, different values of free spectral range of the microwave photonic filter are obtained by employing fiber spools of different lengths. The reconfigurability of the microwave photonic filter is achieved by varying the number of linearly polarized modes. It has been shown that the passband ripple can be reduced by employing higher order spatial modes and unequal power ratio among different modes. The proposed filter enables application-specific free spectra range tunability and reconfigurability along with added advantages of easy implementation and passband optimization.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7

Similar content being viewed by others

References

  1. Capmany, J., Ortega, B., Pastor, D.: A tutorial on microwave photonic filters. J. Lightwave Technol. 24(1), 201–229 (2006)

    Article  ADS  Google Scholar 

  2. Chang, J., Fok, M.P., Meister, J., Prucnal, P.R.: A single source microwave photonic filter using a novel single-mode fiber to multimode fiber coupling technique. Opt. Express 21(5), 5585–5593 (2013)

    Article  ADS  Google Scholar 

  3. Raza, A., Ghafoor, S., Butt, M.F.U.: MIMO-enabled integrated MGDM-WDM distributed antenna system architecture based on plastic optical fibers for millimeter-wave communication. Photon Netw. Commun. 35(2), 265–273 (2018)

    Article  Google Scholar 

  4. Benyahya, K., Simonneau, C., Ghazisaeidi, A., Barré, N., Jian, P., Morizur, J.-F., Labroille, G., Bigot, M., Sillard, P., Provost, J.G., et al.: Multiterabit transmission over OM2 multimode fiber with wavelength and mode group multiplexing and direct detection. J. Lightwave Technol. 36(2), 355–360 (2018)

    Article  ADS  Google Scholar 

  5. Hazan, Y., Ran, M.: Study of indoor lte green small-cells using mobile fronthaul architecture over hybrid fiber-wireless channels. In: 2016 European Conference on Networks and Communications (EuCNC). IEEE, pp. 185–189, (2016)

  6. Urick, V.J., Williams, K.J., McKinney, J.D.: Fundamentals of microwave photonics. Wiley, Hoboken (2015)

    Book  Google Scholar 

  7. Liu, X., Mididoddi, C. K., Tan, Z., Wang, G., Shao, L., Wang, C.: Tunable multimode optical delay line for single-wavelength microwave photonic transversal filter. In: 2018 International Topical Meeting on Microwave Photonics (MWP), pp. 1–4, (2018)

  8. Lee, K.H., Choi, W.Y., Oh, K.: A novel tunable fiber-optic microwave filter using multimode DCF. IEEE Photonics Technol. Lett. 5(7), 969–971 (2003)

    ADS  Google Scholar 

  9. Mirza, J., Kanwal, B., Ghafoor, S.: Microwave photonic notch filter based on polarisation multiplexing and cross gain modulation in a semiconductor optical amplifier. Electron. Lett. 56(4), 189–192 (2019)

    Article  ADS  Google Scholar 

  10. Umar, F., Mirza, J., Ghafoor, S.: Microwave photonic filtering based on optical carrier suppression modulation. Microwave Opt. Technol. Lett. 62(1), 60–66 (2020)

    Article  Google Scholar 

  11. Capmany, J., Mora, J., Gasulla, I., Sancho, J., Lloret, J., Sales, S.: Microwave photonic signal processing. J. Lightwave Technol. 31(4), 571–586 (2012)

    Article  ADS  Google Scholar 

  12. Agrawal, G.P.: Fiber-optic communication systems, vol. 222. Wiley, Hoboken (2012)

    Google Scholar 

  13. Li, W., Wang, W.T., Sun, W.H., Liu, J.G., Zhu, N.H.: Microwave photonic notch filter with complex coefficient based on DDMZM. IEEE Photonics Technol. Lett. 26(18), 1859–1862 (2014)

    Article  ADS  Google Scholar 

  14. Nickel, D.V., Villarruel, C., Koo, K., Bucholtz, F., Haas, B.: Few mode fiber-based microwave photonic finite impulse response filters. J. Lightwave Technol. 35(23), 5230–5236 (2017)

    Article  ADS  Google Scholar 

  15. Every Thing RF: https://www.everythingrf.com/community/what-are-pass-band-ripples-in-a-filter

  16. Chan, E., Minasian, R.: High-resolution microwave photonic notch filter with low-noise and low group delay ripple performance. In: 30th URSI General Assembly and Scientific Symposium. IEEE 1–4 (2011)

  17. Senior, J.M.: Optical fiber communications: principles and practice. Harlow, England (2004)

    Google Scholar 

  18. Oppenheim, A. V.: Discrete-time signal processing. Pearson Education India, (1999)

  19. Lin, T., Zhao, S., Yin, Y., Zheng, Q.: Tunable microwave photonics filter with dual pass-band based on PM-FBG and PS-FBG. Opt. Quant. Electron. 50(11), 397 (2018)

    Article  Google Scholar 

  20. Han, X., Yao, J.: Bandstop-to-bandpass microwave photonic filter using a phase-shifted fiber Bragg grating. J. Lightwave Technol. 33(24), 5133–5139 (2015)

    Article  ADS  Google Scholar 

  21. Wang, C., Yao, J.: A nonuniformly spaced microwave photonic filter using a spatially discrete chirped FBG. IEEE Photonics Technol. Lett. 25(19), 1889–1892 (2013)

    Article  ADS  Google Scholar 

  22. Zhang, B., Kahrizi, M.: High-temperature resistance fiber Bragg grating temperature sensor fabrication. IEEE Sens. J. 7(4), 586–591 (2007)

    Article  ADS  Google Scholar 

  23. Athermal packaged FBG. http://www.dkphotonics.com/product/athermal-packaged-fbg.html

Download references

Acknowledgements

This research was sponsored by the Deanship of Scientific Research (DSR), King Abdulaziz University, Jeddah, under grant no. (KEP-6-135-41). The authors, therefore, acknowledge with thanks DSR for technical and financial support.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Salman Ghafoor.

Ethics declarations

Conflict of interest

On behalf of all authors, the corresponding author states that there is no conflict of interest.

Additional information

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Mirza, J., Atieh, A., Aljohani, A.J. et al. Design and optimization of a microwave photonic filter exploiting differential mode group delay of a multi-mode fiber. Opt Rev 28, 199–206 (2021). https://doi.org/10.1007/s10043-021-00650-y

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10043-021-00650-y

Keywords

Navigation