Abstract
The production of magnesia pellets is developing in mining enterprises, especially in the context of tightening environmental standards and a decrease in sinter production. In the course of the work, it was determined that from the peculiarities of pellet structure formation, the dolomite influence is manifested in a change in both the thermal conditions of firing (the endothermic effect increases with the decomposition of carbonates) and the mineral composition of the fired product. From the point of view of metallurgical properties, MgO contributes to an increase in the strength upon reduction, as well as an increase in carbonates content in the charge leads to an increase in porosity and reducibility. In general, the use of dolomite makes it possible to improve the quality of iron ore pellets by increasing their metallurgical properties.
Similar content being viewed by others
REFERENCES
Vinogradov, E.N., Kal’ko, A.A., Volkov, E.A., et al., Specific blast furnace technology with low slag yield, Trudy VIII Mezhdunarodnogo kongressa domenshchikov “Metallurgiya chuguna-vyzovy XXI veka” (Proc. VIII Int. Congr. of Blast Furnace Workers “Cast Iron Metallurgy as a Challenge of 21st Century”), Moscow: Kodeks, 2017, pp. 51–58.
Ovchinnikova, E.V., Gorbunov, V.B., Shapovalov, A.N., et al., Magnesia sinter with flux based on magnesium silicate, Steel Transl., 2018, vol. 48, no. 1, pp. 34–38.
Anisimov, N.K., Naftal’, M.N., Maslov, E.V., et al., Modernization of the industry of Ural Steel Works as a part of strategic development of Metalloinvest Holding, Metallurg, 2016, no. 7, pp. 4–6.
Bersenev, I.S., Bersenev, E.S., Bragin, V.V., et al., The effect of basicity and content of magnesium oxide on the quality of iron quartzite pellets, Trudy nauchno-prakticheskoi konferentsii s mezhdunarodnym uchastiem i elementami shkoly molodykh uchenykh “Perspektivy razvitiya metallurgii i mashinostroeniya s ispol’zovaniem zavershennykh fundamental’nykh issledovanii i NIOKR: Ferrosplavy” (Proc. Sci.-Pract. Conf. with Int. Participation and the Elements of School of Young Scientists “Prospective Development of Metallurgy and Machine Engineering Using Completed Fundamental Studies and R&D: Ferroalloys”), Yekaterinburg: Ural’skii Rabochii, 2018, pp. 168–172.
Aksel’rod, L.M., Refractory industry and changes in the commodity market, Chern. Metall., Byull. Nauchno-Tekh. Ekon. Inf., 2017, no. 11, pp. 3–14.
Zhuravlev, F.M. and Malysheva, T.Ya., Okatyshi iz kontsentratov zhelezistykh kvartsitov (Pellets from Ferrous Quartzite Concentrates), Moscow: Metallurgiya, 1991.
Malysheva, T.Ya. and Dolitskaya, O.A., Petrografiya i mineralogya zheleznorudnogo syr’ya: uchebnoe posobie dlya vuzov (Petrography and Mineralogy of Iron Ore: Manual for Higher Education Institutions), Moscow: Mosk. Inst. Stali Splavov, 2004.
Timofeeva, A.S., Nikitchenko, T.V., and Kozhukhov, A.A., The role of magnesium oxide in the physicochemical and metallurgical properties of iron pellets, Chern. Metall., Byull. Nauchno-Tekh. Ekon. Inf., 2018, no. 5, pp. 23–28.
Kretov, S.I., Kozub, A.V., Pigarev, S.P., et al., Roasting machine for client-oriented pellet production, Steel Transl., 2017, vol. 47, no. 12, pp. 814–819.
Bersenev, I.S., Bersenev, E.S., Gorbachev, V.A., et al., Sintering of iron ore pellets from concentrate of the Bystrinskoye deposit, Stal’, 2014, no. 8, pp. 12–13.
Ugarov, A.A., Martinson, V.N., Evsyugin, S.N., and Solodukhin, A.A., Improving the production of iron ore pellets at JSC Lebedinsky GOK, Gorn. Zh., 2017, no. 5, pp. 32–35.
Vinichuk, B.G., Usol’tsev, D.Yu., Voevodin, L.I., et al., Use of bentonite from the new section of the Dash-Salakhlinskoe deposit for the production of iron ore pellets, Stal’, 2008, no. 3, pp. 19–21.
Budanov, I.A., New conditions for the development of the Russian metal market, Stal’, 2018, no. 8, pp. 64–72.
Bersenev, I.S., Bragin, V.V., Ugarov, A.A., et al., Improvement of technical and economic performance of blast-furnace smelting by pellet composition optimization, Steel Transl., 2020, vol. 50, no. 3, pp. 171–178.
Bragin, V.V., Bersenev, I.S., Pokolenko, A.Yu., et al., The strength of calcined iron pellets of Mikhailovsky GOK during their fluxing with dolomite, Materialy VIII Vserossiiskoi nauchno-prakticheskoi konferentsii studentov, aspirantov i molodykh uchenykh s mezhdunarodnym uchastiem (TIM’2019) “Teplotekhnika i informatika v obrazovanii, nauke i proizvodstve,” Ekaterinburg, 16–17 maya 2019 g. (Proc. VIII All-Russ. Sci.-Pract. Conf. of Students, Post-Graduate Students, and Young Scientists with Int. Participation (TIM’2019) “Thermal Engineering and Informatics in Education, Science, and Industry,” Yekaterinburg, May 16–17, 2019), Yekaterinburg: Ural. Fed. Univ., 2019, pp. 24–31.
Bersenev, I.S., Bragin, V.V., Evsyugin, S.N., and Solodukhin, A.A., Improving the quality of iron ore pellets by their fluxing, Materialy IV Mezhdunarodnoi nauchnoi konferentsii “Nauchno-tekhnicheskii progress v chernoi metallurgii-2019” (Proc. IV Int. Sci. Conf. “Scientific-Technical Progress in Ferrous Metallurgy-2019”), Bolobanov, N.L., Ed., Cherepovets: Cherepovetsk. Gos. Univ., 2019, pp. 22–28.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by V. Selikhanovich
About this article
Cite this article
Bersenev, I.S., Bragin, V.V., Evstyugin, S.N. et al. Evolution of Structure and Metallurgical Properties of Iron Ore Pellets When Fluxing with Dolomite, JSC Mikhailovsky GOK Named after A.V. Varichev. Steel Transl. 50, 788–794 (2020). https://doi.org/10.3103/S0967091220110054
Received:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S0967091220110054