Abstract
The move towards processes in small and micro devices has been increased recently due to the enhanced heat and mass rate of these devices. One particular area of application is liquid–liquid extraction. The efficiency of the solvent extraction as a result of two-phase flow in an intensified channel highly depends on the flow patterns. In this work, the hydrodynamics of conventional polyethylene glycol 200 (PEG200) and simulated diesel have been investigated intensively by varying several parameters such as junction shape and diameter, channel diameter, and channel saturation. To study the effect of solvent properties, experiments were carried out by changing the polyethylene glycol to a eutectic solvent (DES) through adding a specific amount of tetra butyl ammonium bromide (TBAB) to the PEG200. The main observed patterns were the drop, plug, various states of annular flow, and irregular flow. Those patterns were highly influenced by the channel diameter. Using DES as a liquid solvent resulted in the development of a different form of plug flow known as plug dispersed. The measured pressure drop was found to raise with rising solvent velocity, solvent viscosity, and decreasing channel diameter. This work gives a clear understanding about the behavior of different solvents to achieve efficient sulfur reduction from liquid fuel in a small scale.
Similar content being viewed by others
Abbreviations
- ID:
-
Internal diameter of the channel mm
- Dh :
-
Hydraulic diameter
- L:
-
Channel length mm
- U:
-
Velocity, m/s
- Q:
-
Volumetric flowrate, m3/s
- A:
-
Cross-sectional area, m2
- ΔP:
-
Pressure drop, kPa
- Re:
-
Reynolds number
- We:
-
Weber’s number
- Ca:
-
Capillary number
- wt %:
-
Weight percent
- µ:
-
Dynamic viscosity, Pa.s
- ρ:
-
Density, kg/m3
- Ƴ:
-
Interfacial tension, N/m
- ε:
-
Volume fraction
- Mix:
-
Mixture
- PEG200:
-
Polyethylene glycol 200
- DES:
-
Deep eutectic solvent
- TBAB:
-
Tetra-N-butylammonium bromide
- F:
-
Fuel
- S:
-
Solvent
References
Ahmed Rahma WS, Mjalli FS, Al-Wahaibi T, Al-Hashmi AA (2017) Polymeric-based deep eutectic solvents for effective extractive desulfurization of liquid fuel at ambient conditions. Chem Eng Res Des 120:271–283
Al Ani Z, Al Wahaibi T, Mjalli FS, Al Hashmi A, Abu-Jdayil B (2017a) Flow of deep eutectic solvent-simulated fuel in circular channels: part II—Extraction of dibenzothiophene. Chem Eng Res Des 119:294–300
Al Ani Z, Al Wahaibi T, Mjalli FS, Al Hashmi A, Abujdayil B (2017b) Flow of deep eutectic solvent-simulated fuel in circular channel: part I—flow patterns and pressure drop. Chem Eng Res Des 119:286–293
Asumana C, Yu G, Li X, Zhao J, Liu G, Chen X (2010) Extractive desulfurization of fuel oils with low-viscosity dicyanamide-based ionic liquids. Green Chem 12:2030
Atencia J, Beebe DJ (2005) Controlled microfluidic interfaces. Nature 437:648
Bultongez KK, Derby MM (2017) Investigation of oil-water flow regimes and pressure drops in mini-channels. Int J Multiphase Flow 96:101–112
Cao Z, Wu Z, Sundén B (2018) Dimensionless analysis on liquid-liquid flow patterns and scaling law on slug hydrodynamics in cross-junction microchannels. Chem Eng J 344:604–615
Fu T, Wei L, Zhu C, Ma Y (2015) Flow patterns of liquid–liquid two-phase flow in non-newtonian fluids in rectangular microchannels. Chem Eng Process 91:114–120
Gano ZS, Mjalli FS, Al-Wahaibi T, Al-Wahaibi Y, AlNashef IM (2014) Solubility of thiophene and dibenzothiophene in anhydrous FeCl3- and ZnCl2-based deep eutectic solvents. Ind Eng Chem Res 53:6815–6823
Gano ZS, Mjalli FS, Al-Wahaibi T, Al-Wahaibi Y, AlNashef IM (2015) Extractive desulfurization of liquid fuel with FeCl3-based deep eutectic solvents: experimental design and optimization by central-composite design. Chem Eng Process 93:10–20
Gao H et al (2008) Desulfurization of fuel by extraction with pyridinium-based ionic liquids. Ind Eng Chem Res 47:8384–8388
Jähnisch K, Hessel V, Löwe H, Baerns M (2004) Chemistry in microstructured reactors. Angew Chem Int Ed 43:406–446
Jovanović J, Zhou W, Rebrov EV, Nijhuis TA, Hessel V, Schouten JC (2011) Liquid–liquid slug flow: hydrodynamics and pressure drop. Chem Eng Sci 66:42–54
Kashid MN, Agar DW (2007) Hydrodynamics of liquid–liquid slug flow capillary microreactor: flow regimes, slug size and pressure drop. Chem Eng J 131:1–13
Kashid M, Renken A, Kiwi-Minsker L (2011) Influence of flow regime on mass transfer in different types of microchannels. Ind Eng Chem Res 50:6906–6914
Mark D, Haeberle S, Roth G, von Stetten F, Zengerle R (2010) Microfluidic lab-on-a-chip platforms: requirements, characteristics and applications. Chem Soc Rev 39:1153–1182
Mjalli FS, Ahmed Rahma WS, Al-Wahaibi T, Al-Hashmi AA (2019) Superior liquid fuel desulfurization through emulsification solvent extraction using polymeric-based eutectic solvents. Chin J Chem Eng. https://doi.org/10.1016/j.cjche.2019.03.033
Qian J-y, Li X-j, Wu Z, Jin Z-j, Sunden B (2019) A comprehensive review on liquid–liquid two-phase flow in microchannel: flow pattern and mass transfer. Microfluid Nanofluidics 23:116
Salim A, Fourar M, Pironon J, Sausse J (2008) Oil-water two-phase flow in microchannels: flow patterns and pressure drop measurements. Can J Chem Eng 86:978–988
Sarkar PS, Singh KK, Shenoy KT, Sinha A, Rao H, Ghosh SK (2012) Liquid-liquid two-phase flow patterns in a serpentine microchannel. Ind Eng Chem Res 51:5056–5066
Sattari-Najafabadi M, Nasr Esfahany M, Wu Z, Sundén B (2017a) The effect of the size of square microchannels on hydrodynamics and mass transfer during liquid-liquid slug flow. AlChE J 63:5019–5028
Sattari-Najafabadi M, Nasr Esfahany M, Wu Z, Sundén B (2017b) Hydrodynamics and mass transfer in liquid-liquid non-circular microchannels: comparison of two aspect ratios and three junction structures. Chem Eng J 322:328–338
Sattari-Najafabadi M, Nasr Esfahany M, Wu Z, Sunden B (2018) Mass transfer between phases in microchannels: a review. Chem Eng Process 127:213–237
Su Y, Zhao Y, Chen G, Yuan Q (2010) Liquid–liquid two-phase flow and mass transfer characteristics in packed microchannels. Chem Eng Sci 65:3947–3956
Sun B, Jiang J, Shi N, Xu W (2016) Application of microfluidics technology in chemical engineering for enhanced safety. Process Saf Prog 35:365–373
Tsaoulidis D, Dore V, Angeli P, Plechkova NV, Seddon KR (2013) Flow patterns and pressure drop of ionic liquid–water two-phase flows in microchannels. Int J Multiphase Flow 54:1–10
Vural Gürsel I, Kockmann N, Hessel V (2017) Fluidic separation in microstructured devices—Concepts and their integration into process flow networks. Chem Eng Sci 169:3–17
Wang J, Zhao R, Han B, Tang N, Li K (2016) Extractive and oxidative desulfurization of model oil in polyethylene glycol. RSC Adv 6:35071–35075
Whitesides GM (2006) The origins and the future of microfluidics. Nature 442:368
Wu Z, Sundén B (2019) Liquid-liquid two-phase flow patterns in ultra-shallow straight and serpentine microchannels. Heat Mass Transfer 55:1095–1108
Wu Z, Cao Z, Sundén B (2017) Liquid-liquid flow patterns and slug hydrodynamics in square microchannels of cross-shaped junctions. Chem Eng Sci 174:56–66
Wu Z, Cao Z, Sunden B (2019) Flow patterns and slug scaling of liquid-liquid flow in square microchannels. Int J Multiphase Flow 112:27–39
Yagodnitsyna AA, Kovalev AV, Bilsky AV (2016) Flow patterns of immiscible liquid-liquid flow in a rectangular microchannel with T-junction. Chem Eng J 303:547–554
Zhao Y, Chen G, Yuan Q (2006) Liquid-liquid two-phase flow patterns in a rectangular microchannel. AlChE J 52:4052–4060
Acknowledgement
The authors would like to thank Sultan Qaboos University and United Arab Emirates University for jointly funding this work (CL/SQU-UAEU/16/02), and would also like to thank Sultan Qaboos University for providing the enabling environment to conduct the study.
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
Conflict of interest
The authors declare no conflict of interest.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Al-Azzawi, M., Mjalli, F.S., Al-Wahaibi, T. et al. Flow patterns analysis of conventional versus eutectic liquid solvent in different circular small channel diameters. Chem. Pap. 75, 753–762 (2021). https://doi.org/10.1007/s11696-020-01340-w
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11696-020-01340-w