Skip to main content
Log in

Detecting Piston Effect on Drilled Shafts Side Resistance Using Instrumented Pile Load Tests

  • Geotechnical Engineering
  • Published:
KSCE Journal of Civil Engineering Aims and scope Submit manuscript

Abstract

The capacity of drilled shafts is strongly related to the method and adequacy of drilling practices. Despite the accumulated knowledge and experience, there is significant variability in the measured performance of drilled shafts. This paper describes the effect of unfavorable drilling practice, not detected with routine checks, on the shaft side resistance after loading. Large diameter drilling buckets create suction inside the drilled hole which is called the piston effect. The paper presents the results of 3 pile load tests, two of which are instrumented. The analysis of results outlines how piston effect can be detected by the examination of measured skin friction coefficients and comparison with calculated bias in an Egyptian pile test database. The paper also presents a numerical simulation of the drilling process and an approximate representation of the piston effect in this simulation. The finite elements model uses coupled analysis to calculate the straining actions in the surrounding soil due to drilling and piston effect. The repeated application of suction leads to hysteresis cycles of deviatoric stresses at large portions of the hole, weakening the soil. Additional cone penetration test (CPT) measurements in the field after performing the test on the piston affected pile prove that the shear applied to the soil around the pile dissipates its peak strength. Hence, side friction with the pile after construction mobilizes only residual strength for a considerable distance above and below the piston affected layer. The paper outlines the indicators needed to detect piston effect in pile load test results.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  • AASHTO (2007) LRFD bridge design specifications. American Association of State Highway and Transportation Officials, Washington DC, USA

    Google Scholar 

  • AASHTO (2014) LRFD bridge design specifications. American Association of State Highway and Transportation Officials, Washington DC, USA

    Google Scholar 

  • AbdelSalam SS, Baligh FA, El-Naggar HM (2015) A database to ensure reliability of bored pile design in Egypt. Proceedings of the Institution of Civil Engineers - Geotechnical Engineering 168(2):131–143, DOI: https://doi.org/10.1680/geng.14.00051

    Article  Google Scholar 

  • AbdelSalam SS, Sritharan S, Suleiman MT (2010) Current design and construction practices of bridge pile foundations with emphasis on implementation of LRFD. Journal of Bridge Engineering 15(6):749–758, DOI: https://doi.org/10.1061/(ASCE)BE.1943-5592.0000118

    Article  Google Scholar 

  • Allen W (2016) Time dependent effect of drilling slurries on side shear resistance of drilled shafts. MSc Thesis, University of South Florida, Tampa, FL, USA

    Google Scholar 

  • Arab MG, Abdelmoghni M, Akl SAY, Dif A (2020) Numerical modeling of unfavorable CFA pile drilling conditions. Geotechnical and Geological Engineering 38:6869–6889, DOI: https://doi.org/10.1007/s10706-020-01475-3

    Article  Google Scholar 

  • Brown D, Turner J, Castelli R (2010) Drilled shafts: Construction procedures and LRFD methods. Federal Highway Administration, Washington DC, USA

    Google Scholar 

  • BS EN 1997-1 (2004) Eurocode EC7: Geotechnical design. British Standard

  • Buscarnera G, Whittle AJ (2013) Model prediction of static liquefaction: Influence of the iinitial state on potential instabilities. Journal of Geotechnical and Geoenvironmental Engineering 139(3):420–432, DOI: https://doi.org/10.1061/(ASCE)GT.1943-5606.0000779

    Article  Google Scholar 

  • Chen YJ, Kulhawy FH (1994) Case history evaluation of drilled shaft behavior. Electric Power Research Institute, Palo Alto, CA, USA

    Google Scholar 

  • Chen YJ, Kulhawy FH (2002) Evaluation of drained axial capacity for drilled shafts. International deep foundations congress 2002, February 14–16, Orlando, FL, USA

  • Chen YJ, Lin SA, Chang HW, Marcos MC (2011) Evaluation of side resistance capacity for drilled shafts. Journal of Marine Science and Technology 19(2):210–221, DOI: https://doi.org/10.6119/JMST.201104J9(2).0013

    Google Scholar 

  • Chin F (1970) Estimation of the ultimate load of piles not carried to failure. Proceedings of the 2nd Southeast Asian conference on soil engineering, June 11–15, Singapore, 81–90

  • Davisson M (1972) High capacity piles. In: Proceedings of soil mechanics lecture series on innovations in foundation construction, American Society of Civil Engineers (ASCE), Chicago, IL, USA, 81–112

    Google Scholar 

  • de Lima LC (2017) Effects on the side shear of drilled shafts. PhD Thesis, University of South Florida, Tampa, FL, USA

    Google Scholar 

  • de Lima LC, Allen W, Mullins G (2018) Effects of drilling slurry on the side shear of drilled shafts over time. IFCEE 2018, March 5–10, Orlando, FL, USA, 622–631

  • ECP (2007) Part 4, Deep foundations. Egyptian Code of Practice for Geotechnical Engineering, Housing and Building Research Center, Cairo, Egypt

    Google Scholar 

  • Elgamal A, Yang Z, Parra E (2002) Computational modeling of cyclic mobility and post-liquefaction site response. Soil Dynamics and Earthquake Engineering 22(4):259–271, DOI: https://doi.org/10.1016/S0267-7261(02)00022-2

    Article  Google Scholar 

  • Elgamal A, Yang Z, Parra E, Ragheb A (2003) Modeling of cyclic mobility in saturated cohesionless soils. International Journal of Plasticity 19(6):883–905, DOI: https://doi.org/10.1016/S0749-6419(02)00010-4

    Article  Google Scholar 

  • GEO (2006) Pile design and construction. Geotechnical Engineering Office, Hong Kong

    Google Scholar 

  • Hassan KM, O’Neill MW (1997) Side load-transfer mechanisms in drilled shafts in soft argillaceous rock. Journal of Geotechnical and Geoenvironmental Engineering 123(2):145–152, DOI: https://doi.org/10.1061/(ASCE)1090-0241(1997)123:2(145)

    Article  Google Scholar 

  • Kulhawy FH (1991) Drilled shaft foundations. In: Fang HY (ed) Foundation engineering handbook. Springer, Boston, MA, USA, 537–552

    Chapter  Google Scholar 

  • Kulhawy FH, O’Rourke TD, Stewart JP, Beech JF (1983) Transmission line structure foundations for uplift-compression loading, load test summaries. Electric Power Research Institute, Washington DC, USA

    Google Scholar 

  • Liang RY, Yamin M (2010) Three-dimensional finite element study of arching behavior in slope/drilled shafts system. International Journal for Numerical and Analytical Methods in Geomechanics 34(11): 1157–1168, DOI: https://doi.org/10.1002/nag.851

    MATH  Google Scholar 

  • Meyerhof GG (1976) Bearing capacity and settlement of pile foundations. Journal of the Geotechnical Engineering Division 102(3):195–228

    Article  Google Scholar 

  • Mullins G, Winters D (2014) Defining the upper viscosity limit for mineral slurries used in drilled shaft construction. FDOT Project No. BDK84-977-24

  • O’Neill MW (1991) Construction practiced and defects in drilled shafts. Transportation Research Record No. 1331

  • O’Neill MW (2001) Side resistance in piles and drilled shafts. Journal of Geotechnical and Geoenvironmental Engineering 127(1):3–16, DOI: https://doi.org/10.1061/(ASCE)1090-0241(2001)127:1(3)

    Article  Google Scholar 

  • O’Neill MW, Reese LC (1973) Behavior of bored piles in beaumont clay. Journal of Geotechnical and Geoenvironmental Engineering, 99(sm7)

    Google Scholar 

  • O’Neill MW, Reese LC (1999) Drilled shafts: Construction procedures and design methods. Fedral Highway Administration, Washington DC, USA

    Google Scholar 

  • Paikowsky S, McVay M, Nguyen T, Al E (2004) LRFD for deep foundations. Transportation Research Board (TRB), Washington, DC, USA

    Google Scholar 

  • Peck RB, Hanson WE, Thornburn TH (1974) Foundation engineering. Wiley, New York, NY, USA

    Google Scholar 

  • Poulos HG (2005) Pile behavior - Consequences of geological and construction imperfections. Journal of Geotechnical and Geoenvironmental Engineering 131(5):538–563, DOI: https://doi.org/10.1061/(ASCE)1090-0241(2005)131:5(538)

    Article  Google Scholar 

  • Poulos HG (2016) A framework for forensic foundation engineering. In: Rao V, Sivakumar Babu G (eds) Forensic geotechnical engineering. Springer, New Delhi, India, 1–15

    Google Scholar 

  • Reese LC, O’Neill MW (1988) Drilled shafts: Construction procedures and design methods. US Department of Transportation, Federal Highway Administration, Office of Implementation, Washington DC, USA

    Google Scholar 

  • Reese LC, O’Neill MW, Touma FT (1976) Behavior of drilled piers under axial loading. Journal of the Geotechnical Engineering Division 102(5):493–510

    Article  Google Scholar 

  • Robertson PK, Campanella RG, Gillespie D, Greig J (1986) Use of piezometer cone data. In: Use of in situ tests in geotechnical engineering, ASCE, New York, NY, USA, 1263–1280

    Google Scholar 

  • Sabatini PJ, Bachus RC, Mayne PW, Schneider JA, Zettler TE (2002) Geotechnical engineering circular no. 5: Evaluation of soil and rock properties. FHWA-IF-02-034

  • Simulia (2013) ABAQUS 6.13 user’s manual. Simulia, Providence, RI, USA

    Google Scholar 

  • The Joint EEFC/DFI Support Fluids Task Group (2019) Guide to support fluids for deep foundations. European Foundation Federation Contractors/Deep Foundation Institute

  • Wang Y, Au SK, Kulhawy FH (2011) Expanded reliability-based design approach for drilled shafts. Journal of Geotechnical and Geoenvironmental Engineering 137(2):140–149, DOI: https://doi.org/10.1061/(ASCE)GT.1943-5606.0000421

    Article  Google Scholar 

  • Wang WL, Yen BC (1974) Soil arching in slopes. Journal of Geotechnical Engineering 100(gt1):61–78

    Google Scholar 

Download references

Acknowledgments

Not Applicable

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Sherif Adel Yahia Akl.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Akl, S.A.Y., Mossaad, M.E. Detecting Piston Effect on Drilled Shafts Side Resistance Using Instrumented Pile Load Tests. KSCE J Civ Eng 25, 822–832 (2021). https://doi.org/10.1007/s12205-021-0914-z

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s12205-021-0914-z

Keywords

Navigation