Abstract
An experimental study on the contact angle dynamic during the impact of single water droplet onto a hot flat practical stainless steel surface under medium weber number was performed. The tested solid material was practical stainless steel of SUS 304. The surface roughness of the hot surface, the static contact angle at ambient pressure, and the diameter of the solid materials were respectively Ra = 0.2 µm, 85.7o, and 30 mm. The surface temperatures were varied from (60–200) oC. The liquid droplet diameter was 2.4 mm. The Weber numbers were 52.1, 57.6, and 63.1. The dynamic contact angles of single droplet during the impact were determined by implementing the developed image processing technique of the obtained video images from experiments. As a result, it was found that (1) the time needed to reach a maximum diameter of single droplet on a flat hot solid surface decreases with the increase of surface temperature, (2) the increase of the Weber number will postpone the spreading of the droplet from its receding, (3) there are three regions of the dynamic contact angle during the liquid evaporation, those are transient spreading region (region 1), a quasi-mechanical equilibrium region (region 2), and transient evaporation region (region 3), and (4) The contact angle in quasi-mechanical equilibrium region the under the nucleate boiling is insensitive to the surface temperature.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Attinger D, Zhao Z, Poulikakos D (2000) An experimental study of molten microdroplet surface deposition: transient behavior and wetting angle dynamics. Trans ASME 122:544–556
Bernardin JD, Mudawar I, Walsh CB, Fransesi EI (1997) Contact angle temperature dependence for water droplets on practical aluminum surfaces. Int J Heat Mass Transf 40(5):1017–1033
Chandra S, Avedisian CT (1991) On the collision of a droplet with a solid surface. Proc R Soc A Math Phys Eng Sci 432:13–41
Clavijo CE, Crockett J, Mayness D (2017) Hydrodynamics of droplet impingement on hot surfaces of varying wettability. Int J Heat Mass Transf 108:1714–1726
Deendarlianto, Takata Y, Hidaka S, Indarto, Widyaparaga A, Kamal S, Purnomo M, Kohno M (2014) Effect of static contact angle on the droplet dynamics during the evaporation of a water droplet on the hot walls. Int J Heat Mass Transf 71:691–705
Deendarlianto, Takata Y, Kohno M, Hidaka S, Wakui T, Majid AI, Kuntoro HY, Indarto, Widyaparaga A (2016) The effects of the surface roughness on the dynamic behavior of the successive micrometric droplets impacting onto inclined hot surfaces. Int J Heat Mass Transf 101:1217–1226
Deendarlianto Takata Y, Widyatama A, Majid AI, Wiranata A, Widyaparaga A, Kohno M, Hidaka S, Indarto, (2018) The interfacial dynamics of the micrometric droplet diameters during the impacting onto inclined hot surfaces. Int J Heat Mass Transf 126:39–51
Guggila G, Narayanaswamy R, Pattamata A (2020) An experimental investigation into the spread and heat transfer dynamics of a train of two concentric impinging droplets over a heated surface. Exp Thermal Fluid Sci 110:109916
Hatta N, Fujimoto H, Kinoshita K, Takuda H (1997) Experimental study of deformation mechanism of a water droplet impinging on hot metallic surfaces above the Leidenfrost temperature (data bank contribution). Trans ASME 119:692–699
Kandlikar SG, Steinke ME (2002) Contact angles and interface behavior during rapid evaporation of liquid on a heated surface. Int J Heat Mass Transf 45:3771–3780
Katoh K, Wakimoto T, Yamamoto Y, Ito T (2015) Dynamic wetting behavior of a triple-phase contact line in several experimental systems. Exp Thermal Fluid Sci 60:354–360
Kim SH, Jiang Y, Kim H (2018) Droplet impact and LFP on wettability and nanostructure surface. Exp Thermal Fluid Sci 99:85–93
Miller A, Neogi P (1985) Interfacial phenomena: equilibrium and dynamic effects (surfactant science series, vol 15). Marcel Dekker, New York
Mitrakusumah WH, Kamal S, Indarto, Susila MD, Deendarlianto (2017) The dynamics of the water droplet impacting onto hot solid surfaces at medium weber numbers. Heat Mass Transfer 53(10):3085–3097
Montoya GA, Deendarlianto, Lucas D, Höhne T, Vallée C (2012) Image-processing-based study of the interfacial behavior of the countercurrent gas-liquid two-phase flow in a hot leg of a PWR. Sci Technol Nucl Installations 209542:1–7
Moreira ALN, Moita AS, Panao MR (2010) Advances and challenges in explaining fuel spray impingement: how much of single droplet impact research is useful? Prog Energy Combust Sci 36:554–580
Roisman IV, Opfer L, Tropea C, Raessi M, Mostaghimi J, Chandra S (2008) Droplet impact onto a dry surface: role of the dynamic contact angle. Colloids Surf A Physicochem Eng Asp 322:183–191
Sikalo S, Tropea C, Ganic EN (2005) Dynamic wetting angle of a spreading droplet. Exp Thermal Fluid Sci 29:795–802
Widyatama A, Dinaryanto O, Indarto, Deendarlianto (2018) The development of image processing technique to study the interfacial behavior of air-water slug-tow-phase flow in horizontal pipes. Flow Meas Instrum 59:168–180
Zappulla MLS, Cho SM, Koric S, Lee HJ, Kim SY, Thomas BG (2020) Multiphysics modeling of continuous casting of stainless steel. J Mater Process Technol 278:116469
Acknowledgements
The work was carried out and funded within the research programs World Class Researcher (WCR) from the Ministry of Research, Technology and Higher Education of the Republic of Indonesia. The contract number is 1985/UN1.DITLIT/DIT-LIT/LT/2019.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Deendarlianto, Pradecta, M.R., Prakoso, T. et al. Contact angle dynamics during the impact of single water droplet onto a hot flat practical stainless steel surface under medium Weber numbers. Heat Mass Transfer 57, 1097–1106 (2021). https://doi.org/10.1007/s00231-020-03010-9
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00231-020-03010-9