Field-scale demonstration of in situ immobilization of heavy metals by injecting iron oxide nanoparticle adsorption barriers in groundwater

https://doi.org/10.1016/j.jconhyd.2020.103741Get rights and content
Under a Creative Commons license
open access

Highlights

  • Ca. 150 m3 iron oxide suspension was injected into a contaminated aquifer for the immobilization of toxic heavy metals.

  • The permeable adsorption barrier of ca. 22 m × 9 m × 3 m did not change the hydraulic conductivity.

  • Downstream concentrations of dissolved heavy metals were strongly reduced.

  • Reduction of metal concentrations was observed at all pH conditions and even below pH 6.

  • Iron oxide nanoparticles have a great potential for in situ immobilization of a wide range of heavy metals in aquifers.

Abstract

Remediation of heavy metal-contaminated aquifers is a challenging process because they cannot be degraded by microorganisms. Together with the usually limited effectiveness of technologies applied today for treatment of heavy metal contaminated groundwater, this creates a need for new remediation technologies. We therefore developed a new treatment, in which permeable adsorption barriers are established in situ in aquifers by the injection of colloidal iron oxides. These adsorption barriers aim at the immobilization of heavy metals in aquifers groundwater, which was assessed in a large-scale field study in a brownfield site.

Colloidal iron oxide (goethite) nanoparticles were used to install an in situ adsorption barrier in a very heterogeneous, contaminated aquifer of a brownfield in Asturias, Spain. The groundwater contained high concentrations of heavy metals with up to 25 mg/L zinc, 1.3 mg/L lead, 40 mg/L copper, 0.1 mg/L nickel and other minor heavy metal pollutants below 1 mg/L. High amounts of zinc (>900 mg/kg), lead (>2000 mg/kg), nickel (>190 mg/kg) were also present in the sediment. Ca. 1500 kg of goethite nanoparticles of 461 ± 266 nm diameter were injected at low pressure (< 0.6 bar) into the aquifer through nine screened injection wells. For each injection well, a radius of influence of at least 2.5 m was achieved within 8 h, creating an in situ barrier of 22 × 3 × 9 m.

Despite the extremely high heavy metal contamination and the strong heterogeneity of the aquifer, successful immobilization of contaminants was observed in the tested area. The contaminant concentrations were strongly reduced immediately after the injection and the abatement of the heavy metals continued for a total post-injection monitoring period of 189 days. The iron oxide particles were found to adsorb heavy metals even at pH-values between 4 and 6, where low adsorption would have been expected. The study demonstrated the applicability of iron oxide nanoparticles for installing adsorption barriers for containment of heavy metals in contaminated groundwater under real conditions.

Keywords

Nanoremediation
Heavy metals
Iron oxide nanoparticles
In situ remediation
Permeable barriers
Contaminated aquifer

Abbreviations

IW
Injection well
MCW
Multichannel well

Cited by (0)

1

Current address: Prosolos, environment – 2625-437 Lisbon, Portugal.