Abstract
A phenomenological model describing fatigue damage accumulation by using a tensor measure of the accumulated damage caused by different cyclic stresses is presented for estimating numerically the fatigue life of carbon fibre-reinforced plastics operating under complex stress state conditions. A procedure for calculating the fatigue life by using the presented model is given. An example demonstrating acceptable agreement between experimental and calculated data is presented.
Similar content being viewed by others
REFERENCES
Fatigue in Composites, Harris, B., Ed., Boca Raton: Woodhead, CRC, 2003.
Fatigue Life Prediction of Composites and Composite Structures, Vassilopoulos, A.P., Ed., Boca Raton: Woodhead, CRC, 2010.
Vassilopoulos, A.P. and Keller, T., Fatigue of Fiber-Reinforced Composites, London: Springer, 2011.
Philippidis, T.P. and Vassilopoulos, A.P., Fatigue strength prediction under multiaxial stress, J. Compos. Mater., 1999, vol. 33, no. 17, p. 1578.
Philippidis, T.P. and Vassilopoulos, A.P., Complex stress state effect on fatigue life of GRP laminates. Part II. Theoretical formulation, Int. J. Fatigue, 2002, vol. 24, no. 8, p. 825.
Kawai, M., A phenomenological model for off-axis fatigue behavior of unidirectional polymer matrix composites under different stress ratios, Composites, Part A, 2004, vol. 35, nos. 7–8, p. 955
Shokrieh M.M. and Lessard, L.B., Fatigue under multiaxial stress systems, in Fatigue in Composites, Harris, B., Ed., Boca Raton: Woodhead, CRC, 2003, p. 63.
Strizhius, V., Fatigue failure criterion of laminated composites under a complex stress-strain state, Mech. Compos. Mater., 2016, vol. 52, no. 3, p. 369.
Donadon, M.V., Arbelo, M.A., Rizzi, P., Montestruque, C.V., Amaro, L., Castro, S., and Shiino, M., A multiaxial fatigue damage model for isotropic materials, in Proceedings of the 30th Symposium of the International Committee on Aeronautical Fatigue, June 2–7,2019, Krakow, Poland, p. 336.
Akivis, M.A. and Goldberg, V.V., Tenzornoe ischislenie (Tensor Calculus with Applications), Moscow: Nauka, 1969; Singapore: World Scientific, 2003.
Pobedrya, B.E., Lektsii po tenzornomu analizu: Ucheb. posobie (Lectures on Tensor Analysis, The School-Book), 3rd ed., Moscow: MGU, 1986, p. 264.
Dimitrienko, Yu.I., Tenzornoe ischislenie: Ucheb. posobie dlya vuzov (Tensor Calculus, The School-Book for Higher School), Moscow: Vyssh. Shkola, 2001, p. 575.
Mandell, J.F., Fatigue behaviour of fibre-resin composites, in Developments in Reinforced Plastics 2, Pritchard, G., Ed., London: Applied Science, 1982, p. 67.
Dudar’kov, Yu.I., Limonin, M.V., and Levchenko, E.A., Free edge effect in laminated composites, Aviats. Prom-st’, 2012, no. 4, p. 48.
Dudar'kov, Yu.I., Levchenko, E.A., and Limonin, M.V., The influence of laminate stacking sequence on layered composites edge effects, Kosmonavtika, 2014, no. 3 (9), p. 25.
Tomblin, J. and Seneviratne, W., Determining the fatigue life of composite aircraft structures using life and load-enhancement factors, Report, DOT/FAA/AR-10/6, 2011.
Sims, G.D., Fatigue test methods, problems and standards, in Fatigue in Composites, Harris, B., Ed., Boca Raton: Woodhead, CRC, 2003, p. 36–62.
Broer, A.A.R., Fatigue life prediction of carbon fibre-reinforced epoxy laminates using a single S-N curve, Master of Science Thesis, Delft: Delft Univ. Technol., 2018.
Rabotnov, Yu.N., Tupolev, A.A., Kut’inov, V.F., Kogaev, V.P., Berezin, A.V., and Sulimenkov, V.V., The use of carbon plastics in the design of aircraft, Mekh. Kompoz. Mater., 1981, no. 4, p. 657.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by Yu. Zikeeva
About this article
Cite this article
Strizhius, V.E. How to Use a Tensor Measure of Accumulated Fatigue Damage for Analyzing the Fatigue Life of Carbon Fibre-Reinforced Plastics under a Complex Stress State. J. Mach. Manuf. Reliab. 49, 38–44 (2020). https://doi.org/10.3103/S1052618820010136
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1052618820010136