Skip to main content
SpringerLink
Log in

The Effect of Hydro-Jex Operation on the Stability of Heap Leach Pads: a Case Study of a Heap Leach Operation in Central Mexico

  • Published:
Mining, Metallurgy & Exploration Aims and scope Submit manuscript

Abstract

Hydro-Jex® is a new enhanced method for heap leach treatment with significantly higher mineral recovery. In this case study at the Los Filos Mine in Mexico, the Hydro-Jex operation is evaluated for heap leach stability. This is pursued by numerical modeling of the heap leach pad stability and well monitoring of the phreatic surface before and after the Hydro-Jex operation. Experimental and numerical results both indicate an improvement in mineral processing under the influence of Hydro-Jex. Numerical results show an insignificant decrease and a significant increase in stability during and after Hydro-Jex injection application, respectively. The integrity of the liner is maintained in both cases. The zonal injection pressure, operationally below the overburden pressure, is found to be negligible compared with the dimensionality of the heap, and stability of the structure is not exposed to any significant risk, even up to 25% above overburden pressure. Furthermore, heap leach factor of safety increases after Hydro-Jex application. This is attributed to breakdown of the water solution build-up and thus a decrease in the phreatic surface depth below the top of the pad. It is suggested that injection wells be drilled, based on thorough geophysical data, in locations where overcompaction of heap material results in water solution build-up and pore pressure enhancement. Compared with traditional heap leaching, the Hydro-Jex technique not only expedites mineral processing by increasing chemical kinetics extraction but also increases the stability of the heap by unclogging drains.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15

Similar content being viewed by others

References

  1. Petersen J (2016) Heap leaching as a key technology for recovery of values from low-grade ores – a brief overview. Hydrometallurgy 165:206–212

    Article  Google Scholar 

  2. Mandziak T, Pattinson D (2015) Experience-based approach to successful heap leach pad design. Mining World 12(5):28–35

    Google Scholar 

  3. Plumlee GS, Edelmann P, Bigelow RC (1995) “The Summitville mine and its downstream effects,” USGS

  4. “http://www.wise-uranium.org,” 2018. [Online]. Available: http://www.wise-uranium.org/mdaf.html

  5. Lyu Z, Chai J, Xu Z, Qin Y, Cao J (2019) “A comprehensive review on reasons for tailings dam failures based on case history.” Adv Civil Eng

  6. Koerner RM, Soong T-Y (2000) “Stability assessment of ten large landfill failures.” Adv Transport Geoenviron Syst Using Geosynthetics, pp. 1–38

  7. Mortazavi A, Abbasloo Z, Ebrahimi L, Keshavarz A, Masoomi A (2015) Geotechnical investigation and design of leaching heap no. 2, Meydook copper mine, Iran. Miner Eng 79:185–195

    Article  Google Scholar 

  8. Karimi Nasab S, Atashpanjeh A, Mollaei Fard M (2001) “Design considerations of heap leaching at Sarcheshmeh open pit copper mine.” In 17th International Mining Congress and Exhibition of Turkey- IMCET2001

  9. Zanbak C (2012) “Heap leaching technique in mining within the context of best available techniques,” Euromines, The European Association of Mining Industries, Metal Ores & Industrial Minerals

  10. Breitenbach AJ (2005) “Heap leach pad design and construction practices in the 21st century,” Vector Colorado LLC

  11. Ulrich B (2008) “Geotechnical aspects of the Hydro-Jex operation,” in 1st International Seminar on the Managment of Rock Dumps, Stockpiles, and Heap Leach Pads, Perth, Australia

  12. Richard Thiel MES (2004) State of the practice review of heap leach pad design issues. Geotext Geomembr 22(6):555–568

    Article  Google Scholar 

  13. Ayala R, Parra D, Valdivia R (2013) “Design and construction review of a heap leach pad for safe operation,” in 1st International Heap Leach Solutions Conference, pp. 321–331

  14. Coulibaly Y, Tikou B, Cheng L (2017) Numerical analysis and geophysical monitoring for stability assessment of the Northwest tailings dam at Westwood mine. Int J Min Sci Technol 27:701–710

    Article  Google Scholar 

  15. Reyes A, Ayala R, Canabi L, Zuta J, Marroqum R, Rodriguez J (2016) “3D dynamic analysis of a valley-fill heap leach pad,” in Heap Leach Mining Solutions, Lima, Peru

  16. Reyes A, Garma P, Parra D (2014) “3D slope stability analysis of heap leach pads using the limit equilibrium method,” Lima, Peru

  17. Ghorbani Y, Franzidis J, Petersen J (2016) Heap leaching technology—current state, innovations, and future directions: a review. Miner Process Extr Metall Rev 37(2):73–119

    Google Scholar 

  18. Winterton J, Rucker D (2013) “Optimal strategies for leach pad injection operations,” Phoenix, AZ

  19. Padilla GA, Cisternas LA, Cuetoa JY (2008) On the optimization of heap leaching. Miner Eng 21(9):673–678

    Article  Google Scholar 

  20. Seal T (2007) “Hydro-Jex: heap leach pad stimulation technology; ready for world wide industrial adoption?” Denver, Colorado, USA

  21. Seal T (2004) “Enhanced gold extraction in cyanide heap leaching using Hydro-Jex,” Ph.D. Dissertation, University of Idaho

  22. Seal T, Rucker D, Winterton J, Ashanti A (2012) “Enhancing gold recovery using Hydro-Jex© at Cripple Creek and Victor Gold Mine Co.,” Denver

  23. Seal T, Jung S (2005) “Reduction of gold inventory in cyanide heap leaching,” SME Annual Meeting and Exhibit, Preprint No. 05-22, Salt Lake City, Utah, USA

  24. Rucker DF (2015) Deep well rinsing of a copper oxide heap. Hydrometallurgy 153:145–153

    Article  Google Scholar 

  25. Rucker DF, McNeill M, Schindler A, Noonan G (2009) Monitoring of a secondary recovery application of leachate injection into a heap. Hydrometallurgy 99:238–248

    Article  Google Scholar 

  26. Itasca, “FLAC3D (Fast Lagrangian Analysis of Continua in 3 Dimensions), version 6.0,” Itasca Consulting Group, Inc., Minneapolis, 2017

  27. Basi J, Rucker D, Seal T (2017) “Testing inventory drawdown through pressure injection in the leach pad at Los Filos Mine,” Vancouver, BC, Canada

  28. Abbasi B, Russell D, Taghavi R (2013) “FLAC3D mesh and zone quality,” FLAC/DEM Symposium, China

  29. Azarfar B, Ahmadvand S, Sattarvand J, Abbasi B (2019) Stability analysis of rock structure in large slopes and open-pit mine: numerical and experimental fault modeling. Rock Mech Rock Eng 52(12):4889–4905

    Article  Google Scholar 

Download references

Author information

Authors and Affiliations

  1. Department of Mining and Metallurgical Engineering, University of Nevada, Reno, Reno, NV, 89557, USA

    Behrooz Abbasi, Babak Azarfar, Seyedsaeid Ahmadvand & Thom Seal

  2. Mine Site Infrastructure, Stantec, Edmonton, Canada

    Bryan Ulrich

Authors
  1. Behrooz Abbasi
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Babak Azarfar
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Seyedsaeid Ahmadvand
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. Thom Seal
    View author publications

    You can also search for this author in PubMed Google Scholar

  5. Bryan Ulrich
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Behrooz Abbasi.

Ethics declarations

Conflict of Interest

The authors declare that they have no conflicts of interest.

Additional information

Publisher’s Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Abbasi, B., Azarfar, B., Ahmadvand, S. et al. The Effect of Hydro-Jex Operation on the Stability of Heap Leach Pads: a Case Study of a Heap Leach Operation in Central Mexico. Mining, Metallurgy & Exploration 37, 1583–1592 (2020). https://doi.org/10.1007/s42461-020-00251-4

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s42461-020-00251-4

Keywords

Search

Navigation