• Open Access

Two-parameter model for optimizing target beam distribution with an octupole magnet

Shin-ichiro Meigo, Motoki Ooi, and Hiroshi Fujimori
Phys. Rev. Accel. Beams 23, 062802 – Published 23 June 2020

Abstract

As hadron accelerators achieve increasing beam power, damage to targets is becoming increasingly severe. To mitigate this damage, nonlinear beam optics based on octupole magnets is attractive. Nonlinear optics can decrease the beam-focusing hazard due to failure of the rastering magnet. As a side effect of nonlinear optics, the beam size at the tail is known to expand drastically compared with linear optics, owing to defocusing in the nonlinear case; this may cause severe beam loss downstream of the octupole magnets. Beam shape and beam loss as a side effect of nonlinear optics have thus far been studied via a simplified filament model that ignores beam-divergence spread at the octupole magnet, so that the problem may be treated by a simplified transfer matrix. Several beam-tracking studies have been performed for the specified case given by the specified emittance and Twiss parameters, whereas a simplified model is required for application to the pragmatic beam tuning. In this study, a new generalized model is proposed for application to an octupole magnet, regardless of the filament-model approximation. It is found that the transverse distribution obtained by beam tracking can be specified by the introduction of only two parameters, namely the normalized octupole strength of K8* and the cotϕ of the phase advance from the octupole to the arbitrary position. With the new generalized model, the distribution with allowable beam loss is studied in detail. The best uniform shape is found for specific parameters of K8* and cotϕ that cannot be deduced from the filament model. However, to achieve the flat distribution, a considerable K8* is required, incurring a large beam loss at the position having cotϕ0.5 downstream of the octupole. To achieve the two antagonistic requirements of reduction of the beam-peak density and minimization of the beam loss, the transverse distribution is surveyed for a large range of beam position. It is found that a bell-shaped distribution with K8*1 and cotϕ3 can satisfy requirements. This result is applied to beam transport in the spallation neutron source at J-PARC. The beam profile calculated using nonlinear optics is compared with the experimental result. It is proven that the transverse beam distribution with nonlinear optics and an octupole magnet can be simplified by the present generalized model, which can be applied to other facilities using octupole magnets. The calculation result shows good agreement with the experimental data, and the peak current density is reduced by 50% compared with the linear-optics case with allowable beamwidth and beam loss.

  • Figure
  • Figure
  • Figure
  • Figure
  • Figure
  • Figure
  • Figure
16 More
  • Received 24 March 2020
  • Accepted 3 June 2020

DOI:https://doi.org/10.1103/PhysRevAccelBeams.23.062802

Published by the American Physical Society under the terms of the Creative Commons Attribution 4.0 International license. Further distribution of this work must maintain attribution to the author(s) and the published article’s title, journal citation, and DOI.

Published by the American Physical Society

Physics Subject Headings (PhySH)

Accelerators & Beams

Authors & Affiliations

Shin-ichiro Meigo and Motoki Ooi

  • J-PARC Center, Japan Atomic Energy Agency, Tokai, Ibaraki 319-1195, Japan

Hiroshi Fujimori

  • J-PARC Center, High Energy Accelerator Research Organization (KEK), Tsukuba, Ibaraki 305-0801, Japan

Article Text

Click to Expand

References

Click to Expand
Issue

Vol. 23, Iss. 6 — June 2020

Reuse & Permissions
Author publication services for translation and copyediting assistance advertisement

Authorization Required


×
×

Images

×

Sign up to receive regular email alerts from Physical Review Accelerators and Beams

Reuse & Permissions

It is not necessary to obtain permission to reuse this article or its components as it is available under the terms of the Creative Commons Attribution 4.0 International license. This license permits unrestricted use, distribution, and reproduction in any medium, provided attribution to the author(s) and the published article's title, journal citation, and DOI are maintained. Please note that some figures may have been included with permission from other third parties. It is your responsibility to obtain the proper permission from the rights holder directly for these figures.

×

Log In

Cancel
×

Search


Article Lookup

Paste a citation or DOI

Enter a citation
×