Abstract
This paper focuses on the flow stability of reverse roll coating flows employed in practical applications to coat thin liquid films on substrates of different materials. Other coating methods are available and various computer programs are purported to predict (for each corresponding method) the set of parameters that permit stable coating conditions. The application of these programs yields so-called coating windows for each particular coating setup. Knowing these coating windows permits coating methods to be applied with preknowledge of the sets of parameters for stable coatings. For reverse roll coating, computer codes for predicting coating windows are scarce or even nonexistent, which was the reason for the present work on the analytical considerations described in this paper. The results obtained formed the basis for a reverse roll coating computer program and its applications. The program is described, and computational results are provided. These are compared with experimental data available in the literature. Good agreement was obtained for high capillary number flows, but there were discrepancies between experimental and computational results for lower capillary numbers. The experimental results for low capillary number flows also appeared less reliable, which triggered the present experimental work. Some experimental results are given for low capillary numbers and these results are also compared with corresponding numerical data. It is suggested that a test section should be built consisting of two rollers and one slot die to study experimentally the stability regions of reverse roll coating flows in a rigorous manner.
Similar content being viewed by others
References
Coyle, DJ, Knife and Roll Coating in Liquid Film Coating. Chapman & Hall, London (1997)
Gaskell, PH, Innes, GE, Savage, MD, “An Experimental Investigation of Meniscus Roll Coating.” J. Fluid Mech., 355 17–44 (1998)
Chandio, MS, Webster, MF, “Numerical Simulation for Reverse Roller-Coating with Free Surfaces.” ECCOMAS Computational Fluid Dynamics Conference, Swansea, Wales, UK, 4–7 September 2001
Benkreira, H, Shibata, Y, Ito, K, “Reverse Roll Coating with a Deformable Roll Operating at Negative Gaps.” Chem. Eng. Sci., 165 204–215 (2017)
Hao, Y, Haber, S, “Reverse Roll Coating Flow.” Int. J. Numer. Methods Fluids, 30 635–652 (1999)
Daniels, N, Instabilities in Roll and Slot Coating Flows, Dissertation (1998)
Coyle, DJ, Macosko, CW, Scriven, LE, “The Fluid Dynamics of Reverse Roll Coating.” AIChE J., 36 (2) 161–174 (1990)
Booth, GL, Coating Equipment and Processes. Lockwood Publishing Company, New York (1970)
Booth, GL, “Coating Converting Process: Traditional Methods and New Uses.” 21st Annual IGC Coating Systems Conference, Boston (1990)
Satas, D, Web Processing and Converting Technology and Equipment. Van Nostrand Reinhold, New York (1984)
Taylor, GI, “Cavitation of a Viscous Fluid in Narrow Passages.” J. Fluid Mech., 16 595–619 (1963)
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Zheng, G., Wachter, F., Al-Zoubi, A. et al. Computations of coating windows for reverse roll coating of liquid films. J Coat Technol Res 17, 897–910 (2020). https://doi.org/10.1007/s11998-020-00328-1
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11998-020-00328-1