Abstract
High-order, wall-resolved large eddy simulations (LES) using the spectral element method (SEM) were performed to investigate the gas-exchange process inside a laboratory-scale internal combustion engine (ICE) and study the in-cylinder flow evolution. Using a stabilizing filter, over 30 engine cycles were simulated to generate data for statistical analysis, which demonstrated good agreement in the mean and root mean-squared (rms) phase-averaged velocity fields across three different filter parameter/resolution combinations. The large scale flow motion was characterized during each stage of the engine cycle. Tumble ratio profiles indicate peak values during the intake stroke which decay during compression and are almost non-existent thereafter. The tumble breakdown process is quantified by investigating the evolution of the mean and turbulent kinetic energy over the full cycle, and its effect on the evolution of the momentum and thermal boundary layers is discussed. Algorithmic advances to the computational fluid dynamics (CFD) solver Nek5000, employed in the current study, resulted in significant reduction in the wall-time needed for the simulation of each cycle for mesh resolutions of at least an order of magnitude higher than the current state-of-the-art.
Similar content being viewed by others
References
Heywood, J.: Internal Combustion Engine Fundamentals. McGraw-Hill, New York (1988)
Lumley, J.: Engines : an introduction. Cambridge University Press, Cambridge (1999)
Arcoumanis, C., Hu, Z., Whitelaw, J.: Tumbling motion : a mechanism for turbulence enhancement in spark-ignition engines. SAE paper 900060 (1990)
Borée, J., Miles, P.: In-cylinder flow. In: Encyclopedia of Automotive Engineering. Wiley (2014)
Hill, P., Zhang, D.: The effects of swirl and tumble on combustion in spark-ignition engines. Prog. Energy Combust Sci. 20, 373–429 (1994)
Borée, J., Maurel, S., Bazile, R.: Disruption of a compressed vortex. Phys. Fluids 14(7), 2543–2556 (2002)
Voisine, M., Thomas, T., Borée, J.: Spatio-temporal structure and cycle to cycle variations of an in-cylinder tumbling flow. Exp. Fluids 50, 1393–1407 (2011)
Eckerle, W., Rutland, C., Rohlfing, E., Singh, G., McIlroy, A.: Research needs and impacts in predictive simulation for internal combustion engines (PRESICE). Tech. rep., U.S. DOE Office of Science (2011)
Haworth, D.: Large-eddy simulation of in-cylinder flows. Oil Gas Sci. Technol. 54(2), 175–185 (1999)
Rutland, C.: Large-eddy simulations for internal combustion engines - a review. Int. J. Engine Res 12(421), 421–451 (2011)
Hasse, C.: Scale-resolving simulations in engine combustion process design based on a systematic approach for model development. Int. J. Engine Res. 17(1), 44–62 (2016)
Buhl, S., Gleiss, F., Köhler, M., Hartmann, F., Messig, D., Brücker, C., Hasse, C.: A combined numerical and experimental study of the 3D tumble structure and piston boundary layer development during the intake stroke of a gasoline engine. Flow Turbul. Combust. 98, 579–600 (2017)
Buhl, S., Hartmann, F., Kaiser, S., Hasse, C.: Investigation of an IC engine intake flow based on highly resolved LES and PIV. Oil Gas Sci. Technol, 72(3), 15 (2017)
Ameen, M., Yang, X., Kuo, T. W., Som, S.: Parallel methodology to capture cyclic variability in motored engines. Int. J. Engine Res. 18(4), 366–377 (2017)
Ma, P., Ewan, T., Jainski, C., Lu, L., Dreizler, A., Sick, V., Ihme, M.: Development and analysis of wall models for internal combustion engine simulations using high-speed micro-PIV measurements. Flow Turbul. Combust. 98(1), 283–309 (2016)
Giannakopoulos, G., Frouzakis, C., Boulouchos, K., Fischer, P., Tomboulides, A.: Direct numerical simulation of the flow in the intake pipe of an internal combustion engine. Int. J. Heat Fluid Fl 68(421), 257–268 (2017)
Schmitt, M., Frouzakis, C., Tomboulides, A., Wright, Y., Boulouchos, K.: Direct numerical simulation of multiple cycles in a valve/piston assembly. Phys. Fluids 26(3), 035105 (2014)
Nek5000 version v17.0. Argonne National Laboratory, IL, U.S.A. Available: https://nek5000.mcs.anl.gov
Patera, A.: A spectral element method for fluid dynamics: laminar flow in a channel expansion. J. Comput. Phys. 54(468), 468–488 (1984)
Ho, L., Patera, A.: A Legendre spectral element method for simulation of unsteady incompressible viscous free-surface flows. Comput. Method. Appl. M. 80, 355–366 (1990)
Schmitt, M.: Direct numerical simulations in engine-like geometries. Ph.D. Thesis, Swiss Federal Institute of Technology, Zurich (2014)
Tomboulides, A., Lee, J., Orszag, S.: Numerical simulation of low Mach number reactive flows. J. Sci. Comput. 12(139), 139–167 (1997)
Patel, S., Fischer, P., Min, M., Tomboulides, A.: A characteristic-based spectral element method for moving-domain problems. J. Sci. Comput (2018)
Schiffmann, P., Gupta, S., Reuss, D., Sick, V., Yang, X., Kuo, T.: TCC–III Engine benchmark for Large-Eddy simulation of IC engine flows. Oil Gas Sci. Technol. 71(1), 3 (2016)
Rehm, G., Baum, H.: The equations of motion in thermally driven flows. J. Res National Bureau of Standards 83(3), 297–308 (1978)
Trelis CFD v16.3. CSIMSOFT. Available: https://www.csimsoft.com/trelis-cfd
Ameen, M., Yang, X., Kuo, T. W., Xue, Q., Som, S.: LES For simulating the gas exchange process in a spark ignition engine. Proc. of the ASME ICEF 2(1002) (2015)
Kuo, T. W., Yang, X., Gopalakrishnan, V., Chen, Z.: LES for IC engine flows. Oil Gas Sci. Technol. 69(1), 61–81 (2014)
Liu, K., Haworth, D., Yang, X., Gopalakrishnan, V.: Large-eddy simulation of motored flow in a two-valve piston engine: POD analysis and cycle-to-cycle variations. Flow Turbul. Combust. 91(2), 373–403 (2013)
Schmitt, M., Frouzakis, C., Wright, Y., Tomboulides, A., Boulouchos, K.: Investigation of wall heat transfer and thermal stratification under engine-relevant conditions using DNS. Int. J. Engine Res. 17, 63–75 (2015)
Fischer, P., Mullen, J.: Filter-based stabilization of spectral element methods. C. R. Acad. Sci Paris 332(3), 265–270 (2001)
Enaux, B., Granet, V., Vermorel, O., Lacour, C., Thobois, L., Dugué, V., Poinsot, T.: Large eddy simulation of a motored single-cylinder piston engine : numerical strategies and validation. Flow Turbul. Combust. 86, 153–177 (2011)
Janas, P., Wlokas, I., Böhm, B., Kempf, A.: On the evolution of the flow field in a spark ignition engine. Flow Turbul. Combust 98(1), 237–264 (2017)
Nguyen, T., Proch, F., Wlokas, I., Kempf, A.: Large eddy simulation of an internal combustion engine using an efficient immersed boundary technique. Flow Turbul. Combust. 97, 191–230 (2016)
Hu, B., Banerjee, S., Liu, K., Rajamohan, D., Deur, J., Xue, Q., Som, S., Senecal, P., Pomraning, E.: Large eddy simulation of a turbulent non-reacting spray jet. In: ASME Internal Combustion Engine Division Fall Technical Conference, vol. 2 (2015)
Mare, F. D., Knappstein, R., Baumann, M.: Application of LES-quality criteria to internal combustion engine flows. Comput. Fluids 89, 200–213 (2014)
Schmitt, M., Frouzakis, C., Wright, Y., Tomboulides, A., Boulouchos, K.: Direct numerical simulation of the compression stroke under engine-relevant conditions : Evolution of the velocity and thermal boundary layers. Int. J. Heat Fluid Fl. 91, 948–960 (2015)
Fischer, P., Heisey, K., Min, M.: Scaling limits for PDE-based simulation. AIAA Aviation American Institute of Aeronautics and Astronautics (2015)
Acknowledgements
This research used resources of the Argonne Leadership Computing Facility, which is a DOE Office of Science User Facility supported under Contract DE-AC02-06CH11357. Preliminary simulations were performed at the Swiss National Supercomputing Center (CSCS) under project ID 753. Financial support from the Forschungsvereinigung Verbrennungskraftmaschinen (FVV, project no. 1286: “Wall heat transfer processes in spark ignition engines”), the Swiss Federal Office of Energy (BfE, contract no. SI/501615-01) and the Swiss Competence Center for Energy Research - Efficient Technologies and Systems for Mobility (SCCER Mobility) is gratefully acknowledged (GKG, CEF, KB).
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
Conflict of interests
The authors declare that they have no conflict of interest.
Additional information
Publisher’s Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Giannakopoulos, G.K., Frouzakis, C.E., Fischer, P.F. et al. LES of the Gas-Exchange Process Inside an Internal Combustion Engine Using a High-Order Method. Flow Turbulence Combust 104, 673–692 (2020). https://doi.org/10.1007/s10494-019-00067-3
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10494-019-00067-3