Original Article
Evaluation of tool wear, surface roughness/topography and chip morphology when machining of Ni-based alloy 625 under MQL, cryogenic cooling and CryoMQL

https://doi.org/10.1016/j.jmrt.2019.12.069Get rights and content
Under a Creative Commons license
open access

Abstract

Although nickel-based aerospace superalloys such as alloy 625 have superior properties including high-tensile and fatigue strength, corrosion resistance and good weldability, etc., its machinability is a difficult task which can be solved with alternative cooling/lubrication strategies. It is also important that these solution methods are sustainable. In order to facilitate the machinability of alloy 625 with sustainable techniques, we investigated the effect of minimum quantity lubrication (MQL), cryogenic cooling with liquid nitrogen (LN2) and hybrid-CryoMQL methods on tool wear behavior, cutting temperature, surface roughness/topography and chip morphology in a turning operation. The experiments were performed at three cutting speeds (50, 75 and 100 m/min), fixed cutting depth (0.5 mm) and feed rate (0.12 mm/rev). As a result, CryoMQL improved surface roughness (1.42 µm) by 24.82% compared to cryogenic cooling. The medium level of cutting speed (75 m/min) can be preferred for the lowest roughness value and lowest peak-to-valley height when turning of alloy 625. Further, tool wear is decreased by 50.67% and 79.60% by the use of MQL and CryoMQL compared with cryogenic machining. An interesting result that MQL is more effective than cryogenic machining in reducing cutting tool wear.

Keywords

Hybrid cooling/lubrication
Tool wear
Surface topography
Chip morphology
Ni-based aerospace alloy

Cited by (0)