当前位置: X-MOL 学术Appl. Phys. Rev. › 论文详情
The use of flow type dependent strain reduction factor to improve fiber orientation predictions for an injection molded center-gated disk
Applied Physics Reviews ( IF 12.750 ) Pub Date : 2019-12-09 , DOI: 10.1063/1.5129679
Peter Wapperom, Donald G. Baird

To predict fiber orientation for injection molded parts, it is important to use a slow-kinetics orientation model and pay careful attention to the role of flow kinematics on orientation evolution speed. A model incorporating the impact of flow type on the fiber reorientation rate was tested by comparing with experimental data measured in an injection molded center-gated disk for both short and long glass fiber thermoplastics. Unlike the existing orientation models using a constant factor, a variable strain reduction factor (SRF) is expressed as a function of an objective flow-type parameter reflecting local flow kinematics. The use of this model improved the fiber orientation predictions at locations where the constant SRF, obtained from simple shear flow, deviated significantly from that based on the local flow kinematics.
更新日期:2019-12-31

 

全部期刊列表>>
Springer Nature 2019高下载量文章和章节
化学/材料学中国作者研究精选
《科学报告》最新环境科学研究
ACS材料视界
自然科研论文编辑服务
中南大学国家杰青杨华明
南开大学陈弓课题组招聘启事
中南大学
材料化学和生物传感方向博士后招聘
课题组网站
X-MOL
北京大学分子工程苏南研究院
华东师范大学分子机器及功能材料
中山大学化学工程与技术学院
试剂库存
天合科研
down
wechat
bug