当前位置: X-MOL 学术Chemistryopen › 论文详情
Our official English website, www.x-mol.net, welcomes your feedback! (Note: you will need to create a separate account there.)
Ionic Liquid Based Polymer Gel Electrolytes for Use with Germanium Thin Film Anodes in Lithium Ion Batteries.
ChemistryOpen ( IF 2.3 ) Pub Date : 2019-12-13 , DOI: 10.1002/open.201900313
Louise M McGrath 1 , John Jones 2 , Edwin Carey 2 , James F Rohan 1
Affiliation  

Thermally stable, flexible polymer gel electrolytes with high ionic conductivity are prepared by mixing the ionic liquid 1‐butyl‐1‐methylpyrrolidinium bis(trifluoromethylsulfonyl)imide (C4mpyrTFSI), LiTFSI and poly(vinylidene difluoride‐co‐hexafluoropropylene (PVDF‐HFP). FT‐IR and Raman spectroscopy show that an amorphous film is obtained for high (60 %) C4mpyrTFSI contents. Thermogravimetric analysis (TGA) confirms that the polymer gels are stable below ∼300 °C in both nitrogen and air environments. Ionic conductivity of 1.9×10−3 S cm−2 at room temperature is achieved for the 60 % ionic liquid loaded gel. Germanium (Ge) anodes maintain a coulombic efficiency above 95 % after 90 cycles in potential cycling tests with the 60 % C4mpyrTFSI polymer gel.

中文翻译:

用于锂离子电池中锗薄膜阳极的离子液体基聚合物凝胶电解质。

通过将离子液体1-丁基-1-甲基吡咯烷鎓双(三氟甲基磺酰基)酰亚胺(C 4 mpyrTFSI),LiTFSI和聚(偏二氟乙烯-共六氟丙烯(PVDF-HFP) ).FT -IR和拉曼光谱表明,高含量(60%)的C 4 mpyrTFSI含量可得到非晶膜。热重分析(TGA)证实聚合物凝胶在约300°C的氮气和空气环境下均稳定。负载60%离子液体的凝胶在室温下的离子电导率达到1.9×10 -3  S cm -2,锗(Ge)阳极在60%C的潜在循环测试中经过90个循环后,库仑效率保持在95%以上4 mpyrTFSI聚合物凝胶。
更新日期:2019-12-13
down
wechat
bug