RF current monitoring probes are commonly utilized in measurements of disturbance currents of cables without making direct conductive contact with the source conductor and without modification of its circuit. They must be calibrated by National Metrology Institutes (NMIs) or accredited calibration laboratories in accordance with international standards such as CISPR 16-1-2 or ISO 11452-4. The RF current monitor probe comparison measurements were conducted with 8 participants; five national metrology institutes (NMIs), two designated institutes (DI) and one commercial calibration laboratory at the frequencies 0.01 MHz, 0.1 MHz, 1 MHz, 10 MHz, 100 MHz, 200 MHz, 300 MHz, 400 MHz and 500 MHz in order to obtain the transfer impedance of the RF current monitoring probe. The comparison measurements started in September 2019 and were completed in June 2020.

To reach the main text of this paper, click on Final Report. Note that this text is that which appears in Appendix B of the BIPM key comparison database https://www.bipm.org/kcdb/.

The final report has been peer-reviewed and approved for publication by the CCEM, according to the provisions of the CIPM Mutual Recognition Arrangement (CIPM MRA).

射频电流监测探头通常用于测量电缆的干扰电流，无需与源导体直接导电接触，也无需修改其电路。它们必须由国家计量院 (NMI) 或经认可的校准实验室根据 CISPR 16-1-2 或 ISO 11452-4 等国际标准进行校准。RF 电流监视器探头比较测量由 8 名参与者进行；五个国家计量机构 (NMI)、两个指定机构 (DI) 和一个商业校准实验室，频率依次为 0.01 MHz、0.1 MHz、1 MHz、10 MHz、100 MHz、200 MHz、300 MHz、400 MHz 和 500 MHz获得射频电流监测探头的传输阻抗。

要访问本文的正文，请单击最终报告。请注意，此文本出现在 BIPM 密钥比较数据库 https://www.bipm.org/kcdb/ 的附录 B 中。

根据 CIPM 互认安排 (CIPM MRA) 的规定，最终报告已通过同行评审并由 CCEM 批准发布。