Abstract Considering a fact that flower-like tin sulfide microspheres (for short SnS) sample is easy to fall off when it is used to fabricate sensing test components, PVDF (vinylidene fluoride) was used to glue the sample powder and the gas sensors instead of DI water (deionized water). The SnS were successfully synthesised through a facile hydrothermal method at 180 °C for 24 h. The properties of samples were characterised by utilizing BET, SEM, TEM, etc. The research results showed that the BET surface area and diameter of the samples were 43.87 m2/g and 1.8–4.2 μm, the response to 100 ppm ethanol was 92.96% with PVDF bonded samples at 240 °C, and the response time and recovery time were 1.8 and 90 s, respectively.

中文翻译：

---

PVDF物理结合的水热合成花状SnS微球气体传感器检测乙醇

摘要 考虑到花状硫化锡微球（简称 SnS）样品在制作传感测试元件时容易脱落，采用 PVDF（偏二氟乙烯）代替样品粉末与气体传感器的粘合。去离子水（去离子水）。通过简便的水热法在 180°C 下 24 小时成功合成了 SnS。利用BET、SEM、TEM等手段对样品的性质进行表征。研究结果表明，样品的BET表面积和直径分别为43.87 m2/g和1.8-4.2 μm，对100 ppm乙醇的响应率为92.96% PVDF 粘合样品在 240 °C 下，响应时间和恢复时间分别为 1.8 和 90 秒。