当前位置: X-MOL 学术Int. J. Press. Vessel. Pip. › 论文详情
Our official English website, www.x-mol.net, welcomes your feedback! (Note: you will need to create a separate account there.)
An investigation of additive manufacturing technologies for development of end-use components: A case study
International Journal of Pressure Vessels and Piping ( IF 3 ) Pub Date : 2020-11-01 , DOI: 10.1016/j.ijpvp.2020.104171
Vahid Hassani

Abstract Prior research has shown that additive manufacturing (AM) can be used to make functional and end-use components, however the absence of design guide has led to restricted use of AM in industry. This research aims to redesign a pressure reducer valve integrated into an end-cap as a subcomponent of composite pressure vessel (CPV), which is manufactured by AM. First, a number of design criteria are defined based on the shortcomings of the current pressure reducers manufactured by conventional methods. Then the design procedure is pursued by several iterations using material jetting, material extrusion, and powder bed fusion which are known as commonly used methods of AM. Through this research, the design imperfections and experiences are identified in terms of lessons learned, design rules and an overall design procedure is established.

中文翻译:

用于开发最终用途组件的增材制造技术调查:案例研究

摘要 先前的研究表明,增材制造 (AM) 可用于制造功能性和最终用途组件,但由于缺乏设计指南,增材制造在工业中的使用受到限制。本研究旨在重新设计一种集成到端盖中的减压阀,作为 AM 制造的复合压力容器 (CPV) 的子组件。首先,根据目前通过传统方法制造的减压器的缺点,定义了许多设计标准。然后通过使用材料喷射、材料挤出和粉末床融合的多次迭代来执行设计程序,这些都是常用的 AM 方法。通过这项研究,从经验教训、设计规则和整体设计程序方面找出设计缺陷和经验。
更新日期:2020-11-01
down
wechat
bug