当前位置: X-MOL 学术Therm. Eng. › 论文详情
Our official English website, www.x-mol.net, welcomes your feedback! (Note: you will need to create a separate account there.)
Choice of Filter Material for a Mechanical Filter for Purification of Water after Liming
Thermal Engineering Pub Date : 2020-06-30 , DOI: 10.1134/s0040601520070058
A. A. Panteleev , S. V. Aladushkin , A. S. Kasatochkin , M. M. Shilov , Yu. V. Chudova

Abstract

The possibility of using quartz sand as a filter material for mechanical filters in the schemes of preliminary water treatment in water treatment plants with coagulation and liming at thermal power plants is considered. Comparative experiments on filtering water through quartz sand at the laboratory bench of an operating thermal power plant showed the absence of leaching of silicic acid from sand at pH = 10.0–10.2 and a filtration rate of 7 m/h. The turbidity of the filtrate is close to zero, and the quality of the water obtained after filtering through quartz sand is higher than when filtering through hydroanthracite. Hydroanthracite is characterized by relatively high abrasion and increased cost in comparison with quartz sand. Model experiments were carried out in a wide pH range when filtering water through sand, which showed the absence of a significant release of silicic acid into water. We studied the long-term interaction of water with quartz sand at pH 12, in which there is no intensive release of silicic acid compounds into water. Studies of the quality of the filtrate of mechanical filters loaded with quartz sand and hydroanthracite at a high pH of the treated water were performed. To prevent silicic acid compounds from entering clarified water, it is recommended that the first portion of the filtrate of the mechanical filters be discharged before being put into operation after a long period of inactivity. Recommendations on the use of quartz sand as a filter material in mechanical filters of the preliminary water treatment scheme at thermal power plants are presented.


中文翻译:

灰化后水净化用机械过滤器的过滤材料选择

摘要

考虑了在热电厂的带有凝结和石灰的水处理厂中进行初步水处理的方案中,使用石英砂作为机械过滤器的过滤材料的可能性。在运行中的热电厂的实验室工作台上通过石英砂过滤水的比较实验表明,在pH = 10.0-10.2的情况下,没有从砂中浸出硅酸,过滤速率为7 m / h。滤液的浊度接近于零,并且通过石英砂过滤后获得的水的质量高于通过无烟煤过滤时得到的水的质量。与石英砂相比,水无烟煤的特点是相对较高的磨损和成本增加。当通过沙子过滤水时,在宽pH范围内进行了模型实验,表明没有明显的硅酸释放到水中。我们研究了pH值为12的水与石英砂的长期相互作用,在该过程中硅酸化合物不会大量释放到水中。对在高pH值的处理过的水中装有石英砂和无烟煤的机械过滤器的滤液质量进行了研究。为防止硅酸化合物进入澄清的水中,建议将机械过滤器的滤液的第一部分在长时间不活动后投入运行之前,先将其排出。提出了有关在热电厂的初步水处理方案的机械过滤器中使用石英砂作为过滤材料的建议。我们研究了pH值为12的水与石英砂的长期相互作用,在该过程中硅酸化合物不会大量释放到水中。对在高pH值的处理过的水中装有石英砂和无烟煤的机械过滤器的滤液质量进行了研究。为防止硅酸化合物进入澄清的水中,建议将机械过滤器的滤液的第一部分在长时间不活动后投入运行之前,先将其排出。提出了关于在热电厂的初步水处理方案的机械过滤器中使用石英砂作为过滤材料的建议。我们研究了pH值为12的水与石英砂的长期相互作用,在该过程中硅酸化合物不会大量释放到水中。对在高pH值的处理过的水中装有石英砂和无烟煤的机械过滤器的滤液质量进行了研究。为防止硅酸化合物进入澄清的水中,建议将机械过滤器的滤液的第一部分在长时间不活动后投入运行之前,先将其排出。提出了关于在热电厂的初步水处理方案的机械过滤器中使用石英砂作为过滤材料的建议。对在高pH值的处理过的水中装有石英砂和无烟煤的机械过滤器的滤液质量进行了研究。为防止硅酸化合物进入澄清的水中,建议将机械过滤器的滤液的第一部分在长时间不活动后投入运行之前,先将其排出。提出了有关在热电厂的初步水处理方案的机械过滤器中使用石英砂作为过滤材料的建议。对在高pH值的处理过的水中装有石英砂和无烟煤的机械过滤器的滤液质量进行了研究。为防止硅酸化合物进入澄清的水中,建议将机械过滤器的滤液的第一部分在长时间不活动后投入运行之前,先将其排出。提出了关于在热电厂的初步水处理方案的机械过滤器中使用石英砂作为过滤材料的建议。建议在长时间不活动后将机械过滤器的第一部分滤液排出后再投入运行。提出了关于在热电厂的初步水处理方案的机械过滤器中使用石英砂作为过滤材料的建议。建议在长时间不活动后将机械过滤器的第一部分滤液排出后再投入运行。提出了关于在热电厂的初步水处理方案的机械过滤器中使用石英砂作为过滤材料的建议。
更新日期:2020-06-30
down
wechat
bug