当前位置: X-MOL 学术Mater. Chem. Phys. › 论文详情
Our official English website, www.x-mol.net, welcomes your feedback! (Note: you will need to create a separate account there.)
Enhanced electrochemical glucose oxidation in alkaline solution over indium decorated carbon supported palladium nanoparticles
Materials Chemistry and Physics ( IF 4.6 ) Pub Date : 2020-11-01 , DOI: 10.1016/j.matchemphys.2020.123318
Omer Faruk Er , Aykut Caglar , Hilal Kivrak

Abstract At present, carbon nanotube (CNT) supported In modified Pd catalysts are prepared at varying Pd:In ratios via NaBH4 reduction method to investigate the synergetic effect of Pd and In monometallic catalysts through glucose electrooxidation. These catalysts are characterized by advanced surface analytical techniques, namely, inductively coupled plasma-mass spectrometry (ICP-MS) with Agilent 7800 ICP-MS, N2 adsorption-desorption measurements (BET) with Micromeritics 3Flex equipment Tristar II 3020 equipped, PANalytical Empyrean device-ray diffractometer (XRD), Hitachi HighTech HT7700 high resolution-transmission electron microscope (HR-TEM), and scanning electron microscope (SEM). Electrochemical measurements are performed by using cyclic voltammetry (CV), chronoamperometry (CA), and electrochemical impedance spectroscopy (EIS) by CHI660E potentiostat in a three electrode system. The characterization results show that all catalysts are successfully synthesized at desired molar composition. For PdIn (90:10)/CNT catalyst, the crystal size obtained from HR-TEM is 2.36 nm and BET surface area is 212.28 cm2g-1.5% PdIn(90:10)/CNT catalyst exhibits the best catalytic activity, lowest charge transfer resistance (Rct), and a long term stability compared to Pd, In, other Pd:In bimetallic catalysts. EIS and CA results are in a good agreement with CV results.

中文翻译:

铟装饰的碳负载钯纳米粒子在碱性溶液中增强电化学葡萄糖氧化

摘要 目前,通过NaBH4 还原法制备不同Pd:In 比的碳纳米管(CNT) 负载In 改性Pd 催化剂,以研究Pd 和In 单金属催化剂通过葡萄糖电氧化的协同作用。这些催化剂采用先进的表面分析技术,即电感耦合等离子体质谱 (ICP-MS) 与 Agilent 7800 ICP-MS、N2 吸附-解吸测量 (BET) 与 Micromeritics 3Flex 设备 Tristar II 3020 配备的帕纳科 Empyrean 设备射线衍射仪 (XRD)、日立高科技 HT7700 高分辨率透射电子显微镜 (HR-TEM) 和扫描电子显微镜 (SEM)。电化学测量通过使用循环伏安法 (CV)、计时电流法 (CA)、CHI660E 恒电位仪在三电极系统中的电化学阻抗谱 (EIS)。表征结果表明,所有催化剂均以所需的摩尔组成成功合成。对于 PdIn (90:10)/CNT 催化剂,HR-TEM 获得的晶体尺寸为 2.36 nm,BET 表面积为 212.28 cm2g-1.5% PdIn(90:10)/CNT 催化剂表现出最好的催化活性,最低的电荷转移电阻 (Rct),以及与 Pd、In、其他 Pd:In 双金属催化剂相比的长期稳定性。EIS 和 CA 结果与 CV 结果非常一致。10)/CNT 催化剂与 Pd、In 和其他 Pd:In 双金属催化剂相比,表现出最佳的催化活性、最低的电荷转移电阻 (Rct) 和长期稳定性。EIS 和 CA 结果与 CV 结果非常一致。10)/CNT 催化剂与 Pd、In 和其他 Pd:In 双金属催化剂相比,表现出最佳的催化活性、最低的电荷转移电阻 (Rct) 和长期稳定性。EIS 和 CA 结果与 CV 结果非常一致。
更新日期:2020-11-01
down
wechat
bug