当前位置: X-MOL 学术Aerosol Sci. Technol. › 论文详情
Our official English website, www.x-mol.net, welcomes your feedback! (Note: you will need to create a separate account there.)
Aerosol Generation by Modern Flush Toilets
Aerosol Science and Technology ( IF 5.2 ) Pub Date : 2013-09-01 , DOI: 10.1080/02786826.2013.814911
David Johnson 1 , Robert Lynch 1 , Charles Marshall 1 , Kenneth Mead 2 , Deborah Hirst 2
Affiliation  

A microbe-contaminated toilet will produce bioaerosols when flushed. We assessed toilet plume aerosol from high efficiency (HET), pressure-assisted high efficiency (PAT), and flushometer (FOM) toilets with similar bowl water and flush volumes. Total and droplet nuclei “bioaerosols” were assessed. Monodisperse 0.25–1.9-μm fluorescent microspheres served as microbe surrogates in separate trials in a mockup 5 m3 water closet (WC). Bowl water seeding was approximately 1012 particles/mL. Droplet nuclei were sampled onto 0.2-μm pore size mixed cellulose ester filters beginning 15 min after the flush using open-face cassettes mounted on the WC walls. Pre- and postflush bowl water concentrations were measured. Filter particle counts were analyzed via fluorescent microscopy. Bowl headspace droplet count size distributions were bimodal and similar for all toilet types and flush conditions, with 95% of droplets <2 μm diameter and >99% <5 μm. Up to 145,000 droplets were produced per flush, with the high-energy flushometer producing over three times as many as the lower energy PAT and over 12 times as many as the lowest energy HET despite similar flush volumes. The mean numbers of fluorescent droplet nuclei particles aerosolized and remaining airborne also increased with flush energy. Fluorescent droplet nuclei per flush decreased with increasing particle size. These findings suggest two concurrent aerosolization mechanisms—splashing for large droplets and bubble bursting for the fine droplets that form droplet nuclei. Copyright 2013 American Association for Aerosol Research

中文翻译:

现代抽水马桶产生气溶胶

被微生物污染的马桶在冲水时会产生生物气溶胶。我们评估了来自高效 (HET)、压力辅助高效 (PAT) 和冲洗阀 (FOM) 马桶的马桶羽状气溶胶,其马桶水和冲洗量相似。评估了总核和液滴核“生物气溶胶”。单分散 0.25–1.9-μm 荧光微球在 5 m3 抽水马桶 (WC) 样机中的单独试验中充当微生物替代物。碗水播种大约为 1012 个颗粒/mL。在冲洗后 15 分钟开始,使用安装在 WC 壁上的开口盒将液滴核取样到 0.2-μm 孔径的混合纤维素酯过滤器上。测量冲洗前和冲洗后的碗水浓度。通过荧光显微镜分析过滤器颗粒计数。对于所有马桶类型和冲洗条件,碗顶空间液滴计数尺寸分布是双峰的并且相似,95% 的液滴直径 <2 μm,> 99% <5 μm。每次冲洗最多可产生 145,000 个液滴,尽管冲洗量相似,但高能量冲洗阀产生的水滴是低能量 PAT 的三倍多,是最低能量 HET 的 12 倍多。雾化和残留在空气中的荧光液滴核粒子的平均数量也随着冲洗能量的增加而增加。每次冲洗的荧光液滴核随着粒径的增加而减少。这些发现表明存在两种并发的雾化机制——大液滴的飞溅和形成液滴核的细液滴的气泡破裂。版权所有 2013 美国气溶胶研究协会 95% 的液滴直径 <2 μm,> 99% <5 μm。每次冲洗可产生多达 145,000 个液滴,尽管冲洗量相似,但高能量冲洗阀产生的水滴是低能量 PAT 的三倍多,是最低能量 HET 的 12 倍多。雾化和残留在空气中的荧光液滴核粒子的平均数量也随着冲洗能量的增加而增加。每次冲洗的荧光液滴核随着粒径的增加而减少。这些发现表明存在两种并发的雾化机制——大液滴的飞溅和形成液滴核的细液滴的气泡破裂。版权所有 2013 美国气溶胶研究协会 95% 的液滴直径 <2 μm,> 99% <5 μm。每次冲洗最多可产生 145,000 个液滴,尽管冲洗量相似,但高能量冲洗阀产生的水滴是低能量 PAT 的三倍多,是最低能量 HET 的 12 倍多。雾化和残留在空气中的荧光液滴核粒子的平均数量也随着冲洗能量的增加而增加。每次冲洗的荧光液滴核随着粒径的增加而减少。这些发现表明存在两种并发的雾化机制——大液滴的飞溅和形成液滴核的细液滴的气泡破裂。版权所有 2013 美国气溶胶研究协会 尽管冲洗量相似,但高能量冲洗阀产生的能量是低能量 PAT 的三倍多,是最低能量 HET 的 12 倍多。雾化和残留在空气中的荧光液滴核粒子的平均数量也随着冲洗能量的增加而增加。每次冲洗的荧光液滴核随着粒径的增加而减少。这些发现表明存在两种并发的雾化机制——大液滴的飞溅和形成液滴核的细液滴的气泡破裂。版权所有 2013 美国气溶胶研究协会 尽管冲洗量相似,但高能量冲洗阀产生的能量是低能量 PAT 的三倍多,是最低能量 HET 的 12 倍多。雾化和残留在空气中的荧光液滴核粒子的平均数量也随着冲洗能量的增加而增加。每次冲洗的荧光液滴核随着粒径的增加而减少。这些发现表明存在两种并发的雾化机制——大液滴的飞溅和形成液滴核的细液滴的气泡破裂。版权所有 2013 美国气溶胶研究协会 每次冲洗的荧光液滴核随着粒径的增加而减少。这些发现表明存在两种并发的雾化机制——大液滴的飞溅和形成液滴核的细液滴的气泡破裂。版权所有 2013 美国气溶胶研究协会 每次冲洗的荧光液滴核随着粒径的增加而减少。这些发现表明存在两种并发的雾化机制——大液滴的飞溅和形成液滴核的细液滴的气泡破裂。版权所有 2013 美国气溶胶研究协会
更新日期:2013-09-01
down
wechat
bug