当前位置：
X-MOL 学术
›
J. Cryst. Growth
›
论文详情
Our official English website, www.x-mol.net, welcomes your feedback! (Note: you will need to create a separate account there.)
Finite Element Design for the HPHT Synthesis of Diamond
Journal of Crystal Growth ( IF 1.8 ) Pub Date : 2018-06-01 , DOI: 10.1016/j.jcrysgro.2017.12.021 Rui Li , Mingming Ding , Tongfei Shi
Journal of Crystal Growth ( IF 1.8 ) Pub Date : 2018-06-01 , DOI: 10.1016/j.jcrysgro.2017.12.021 Rui Li , Mingming Ding , Tongfei Shi
Abstract The finite element method is used to simulate the steady-state temperature field in diamond synthesis cell. The 2D and 3D models of the China-type cubic press with large deformation of the synthesis cell was established successfully, which has been verified by situ measurements of synthesis cell. The assembly design, component design and process design for the HPHT synthesis of diamond based on the finite element simulation were presented one by one. The temperature field in a high-pressure synthetic cavity for diamond production is optimized by adjusting the cavity assembly. A series of analysis about the influence of the pressure media parameters on the temperature field are examined through adjusting the model parameters. Furthermore, the formation mechanism of wasteland was studied in detail. It indicates that the wasteland is inevitably exists in the synthesis sample, the distribution of growth region of the diamond with hex-octahedral is move to the center of the synthesis sample from near the heater as the power increasing, and the growth conditions of high quality diamond is locating at the center of the synthesis sample. These works can offer suggestion and advice to the development and optimization of a diamond production process.
更新日期：2018-06-01
京公网安备 11010802027423号